Loading ...
Loading ...
Loading ...
Interior Features ....................................................
Shelves
Tempered Glass Cantilever Shelves
These shelves are adjustable so the refrigerator interior
can be customized for varying food storage needs.
To remove a shell': Unload Lift up the rear of the shelf
slightly, pull the shelf straight out
To move a shelf to a different position: After
removing, tilt up the front edge of the shelf Insert the
hooks into the desired openings and let the shelf settle
into place Be sure the shelf is securely locked at the rear
SpilI-CatcheF Shelves (select models)
Spill-Catcher '_'shelves have a spill retainer edge to con-
tain spills and make clean-up easier.
Some Spill-Catcher _" shelves, feature the Easy Glide
slide-out feature. To slide out, grasp the front of the
shelf and pull forward. Push the shelf in to return to
original position,
_lb WARNING m Never attempt to adjust
a shelf that is loaded with food (except
the Elevator TM shelf - see above).
ElevatoF" Shelf (select models)
The Elevator" shelf is equipped with a spill-retaining
edge and the Easy Glide slide out feature It can be
adjusted up or down without unloading To slide out,
grasp the front of the shelf and pull forward Push the
shelf in to return to original position
To adjust the Elevator'" shelf: Untbld the recessed
crank handle so it is at a right angle to the shelf front
Crank to the right (clockwise) to raise the shelf, or to the
left (counterclockwise) to lower the shelf
To remove: Unload the shelf Grasp the shelf front and
pull completely forward Press up on the stops (both
sides) and continue pulling the shelf forward, clear of
the frame
To replace: Align the shelf to the frame and push it all
the way back It is not necessary to depress the stops for
reinstallation
In ordinary use, the Elevator' shelf frame assembly does
NOT require removal Though unlikely, and not recom
mended, the correct removal procedure is as follows:
• Unload the shelf completely
• Slide the shelf forward about two inches and manu
ally move the two rear latches toward the shelf center
• While supporting the entire shelf and frame from
underneath, lift slightly and rotate the assembly
approximately 30 ° to allow the rear mechanism to
clear the vertical rear side rails
• The entire assembly can then be moved tbrward and
clear of the refrigerator compartment
• To reinstall, reverse the removal procedure Be sure
the shelf is in a level position When the sliding
shelf is pushed to the rear, it will reposition the rear
latches to their correct operating position
LATCHES
4
Loading ...
Loading ...
Loading ...