Installation Instructions
Maintop Rear Filler Kit for Electric Slide-In and Drop-In
Installation for Slide-In Range
When the range is installed, the filler bracket should fill the gap completely. If a small gap occurs, the
front of the countertop may be cut back slightly in the control panel area to close the gap. The filler
panel is 30” wide to fit between an upswept countertop and does not match the outside edge of the
glass. The dimension between the end of the rear filler panel and edge of the glass is approx. 5/8” on
each side.
A
A1
Prior to installing the range, place the metal filler piece to the back of the range as shown in
Fig. 1.
A2
When the trim is set in the proper position, tighten the 2 mounting screws. The top of the trim
should be located below the top surface of the glass to prevent pots, pans and skillets from
damaging the painted part.
A3
Pub. No. 31-10453
229C4053P433
Start the 2 screws through the slots in the trim, into the upper holes at the outside rear of the
range above the louvers. Hold the filler piece centered on the glass cooktop and push upward
to close the gap between the bottom of the glass and the filler trim.
The purpose of the maintop rear filler kit is to fill the gap between the back of the range and the wall.
(25” standard depth) For all dimensions refer to the Installation Instructions of your range.
Tools Required:
1/4” Hex Head Driver
Parts Supplied:
Maintop Filler Trim
2 Screws
Maintop Filler
Range
Cooktop
(
2
)
#8 Screws
Fig.1
Countertop
Make sure the edge
of the countertop fits flush
against the end of the
Front Control Panel
Loading ...
