Loading ...
Loading ...
Loading ...
5
Planning the Installation
Cabinet Layout
• All maximum and minimum dimensions and clearances shown in the diagrams below must be maintained for safe operation.
• Check the location where the range is to be installed. It should be placed away from drafts that may be caused by doors, windows
and heating and air conditioning outlets.
• To reduce the risk of fire or personal injury from reaching over a hot appliance, avoid cabinet installations directly above the range.
If cabinet storage is to be provided, the risk can be reduced by installing a range hood that projects horizontally a minimum of 5
inches beyond the bottom of the cabinets.
• The range may be installed flush to the rear wall. Dacor strongly recommends installing a non-combustible material on the rear
wall above the range and up to the vent hood or installation of a backguard. It is not necessary to install non-combustible materials
behind the range below the countertop height. Any openings in the wall behind the appliance or in the floor underneath it must be
sealed.
DIMENSIONS
Range Model F G H I J
RNRP36G
42” (106.2 cm)*
36” (91.4 cm)**
36”
(91.4 cm)**
33 1/2”
(84.8 cm)
30 7/8”
(78.4 cm)
3 1/2”
(8.9 cm)
RNRP48G
54” (137.2 cm)*
48” (121.9 cm)**
48”
(121.9 cm)**
43 1/2”
(110.2 cm)
29 7/8”
(75.9 cm)
3”
(7.6 cm)
* Recommended ** Minimum
Note 2
F
G
2
Cabinet/countertop depth is at discretion of customer but
cabinet face MUST NOT protrude further than rear of front
panel, see product dimensions.
3
Consult local code for exact location requirements.
1
Vertical from range grate level to combustible overhead
surface; if installing an overhead vent hood, also check
hood specifications for minimum required clearances.
4
Vertical from grate level to combustible surface.
Non-combustible
surface along back wall
recommended
10” (25.4 cm) min.
to combustible side
walls above the range
(both sides)
30” (76.2 cm)
min.
1
37 1/2”
(95.3 cm)
max.
13” (33.0 cm)
max.
5
15” (38.1 cm)
min.
4, 5
5
This specification does not apply for cabinets more
than a horizontal distance of 10” (25.4 cm) from the
edge of the range.
Suggested
location of
utilities
3
Grate
level
G
10" (25.4 cm) min.
to combustible side
walls above the range
(on both sides)
non-combustible
rear wall (recommended)
H
Backsplash
3/8" (1.0 cm)
min. for downdraft cap
clearance
J
Note 2
Cutout tolerances: +1/16” (+1.6 mm), -0
unless otherwise stated
Loading ...
Loading ...
Loading ...