Loading ...
Loading ...
Loading ...
This appliance is marked according to the
European directive 2002/96/EC on Waste
Electrical and Electronic Equipment (WEEE).
By ensuring this product is disposed of
correctly, you will help prevent potential
negative consequences for the environment
and human health, which could otherwise be
caused by inappropriate waste handling of
this product.
The symbol
on the product, or on the
documents accompanying the product,
indicates that this appliance may not be
treated as household waste. Instead it should
be taken to the appropriate collection point for
the recycling of electrical and electronic
equipment. Disposal must be carried out in
accordance with local environmental
regulations for waste disposal.
For further detailed information regarding the
process, collection and recycling of this
product, please contact the appropriate
department of your local authorities or the
local department for household waste or the
shop where you purchased this product.
Appliance designed, tested and manufactured
according to:
• Safety: EN/IEC 60335-1; EN/IEC 60335-2-
31, EN/IEC 62233.
• Performance: EN/IEC 61591; ISO 5167-1;
ISO 5167-3; ISO 5168; EN/IEC 60704-1;
EN/IEC 60704-2-13; ISO 3741; EN 50564;
IEC 62301.
• EMC: EN 55014-1; CISPR 14-1; EN 55014-
2; CISPR 14-2; EN/IEC 61000-3-2; EN/IEC
61000-3-3. Suggestions for a correct use in
order to reduce the environmental impact:
Switch ON the hood at minimum speed when
you start cooking and kept it running for few
minutes after cooking is finished. Increase the
speed only in case of large amount of smoke
and vapour and use boost speed(s) only in
extreme situations. Replace the charcoal
filter(s) when necessary to maintain a good
odour reduction efficiency. Clean the grease
filter(s) when necessary to maintain a good
grease filter efficiency. Use the maximum
diameter of the ducting system indicated in
this manual to optimize efficiency and
minimize noise.
Additional Installation Specifications:
Use only the fixing screws supplied with the
product for installation or, if not supplied,
purchase the correct screws type.
Use the correct length for the screws which
are identified in the Installation Guide.
In case of doubt, consult an authorised
service assistance centre or similar qualified
person.
WARNING! Failure to install the screws or
fixing device in accordance with these
instructions may result in electrical hazards.
USE
The hood is designed to be used either for
exhausting or filter version.
Ducting version
In this case the fumes are conveyed outside
of the building by means of a special pipe
connected with the connection ring located on
top of the hood.
Attention! The exhausting pipe is not
supplied and must be purchased apart.
Diameter of the exhausting pipe must be
equal to that of the connection ring.
In the horizontal runs the exhausting pipe
must be slightly slanted (about 10°) and
directed upwards to vent the air easily from
the room to the outside.
Attention! If the hood is supplied with active
charcoal filter, then it must be removed.
Connect the hood and discharge holes on the
walls with a diameter equivalent to the air
outlet (connection flange).
Using the tubes and discharge holes on walls
with smaller dimensions will cause a
diminution of the suction performance and a
drastic increase in noise.
Any responsibility in the matter is therefore
declined.
! Use a duct of the minimum indispensible
length.
! Use a duct with as few elbows as possible
(maximum elbow angle: 90°).
41
Loading ...
Loading ...
Loading ...