Loading ...
Loading ...
Loading ...
12
Digital Dial Operation
Digital Dial option is available on some models only.
The switching operation of this
microwave oven can cause voltage
uctuations on the supply line.
The operation of this oven under
unfavorable voltage supply conditions
can have adverse effects. This device
is intended for the connection to a
power supply system with a maximum
permissible system impedance Zmax
of 0.2 Ohms at the interface point of
the user’s supply. The user has to
ensure that this device is connected
only to a power supply system
which fullls the requirement above.
If necessary, the user can ask the
public power supply company for the
system impedance at the interface
point.
Oven Wall Clearances
A—For North American (UL/CSA) models,
allow at least 2” (5.1 cm) of clearance
around top of oven. For International (50
Hz) models, allow at least 12” (30 cm) of
clearance around top of oven. Proper air ow
around oven cools electrical components.
With restricted air ow, oven may not
operate properly and life of electrical parts is
reduced.
B—Allow at least 2” (5.1 cm) between air
discharge on back of oven and back wall.
C—Allow at least 2” (5.1 cm) of clearance
around sides of oven.
No metal pans
DO NOT power spray
So...how do I use it? (Digital Dial)
Heating
1. Open oven door, place food in oven, and close oven door.
2. Turn time entry knob clockwise to desired time.
• Cooking time can be set up to 6 minutes.
• Oven begins operation and time counts down.
3. When cooking time has elapsed, microwave energy stops and oven
signal sounds.
Interrupting Operation
Open oven door to interrupt operation or turn time entry knob
counterclockwise to “0”. To resume microwave oven operation, close oven
door.
If time was changed to “0”, time will need to be reset.
Changing Time and Canceling Mistakes
Heating time can be changed at any time while the oven is operating.
Turn knob to desired new setting. To set cooking time to zero, turn knob
counterclockwise to “0”.
B
A
C
STYLE 1
Loading ...
Loading ...
Loading ...