Loading ...
Loading ...
Loading ...
h) Check to ensure that the clawfoot is aligned
properly with the bathtub and is sitting snug
against the bathtub.
Once this is done, use a wrench to tighten all
of the nuts.
h) Take (1) washer [#5] and place it over the bolt
on the metal plate. Then take (1) nut with washer
[#6] and screw it into the bolt. Do not tighten.
Repeat the same step for the lower bolt. Once
this is done, use a wrench to tighten all of the nuts.
i) Repeat the same procedure for the other 3 legs. i) Repeat the same procedure for the other 3 legs.
The following drain installation is applicable to drain models N-DWF-CH & N-DWF-GLD. Please skip to
step 12 for drain model A-1840-0.
7. Take the strainer, place silicone sealant around it, and then place it into the drain hole ensuring
a tight connection with the drain ell & gasket. Use silicone sealant. DO NOT use plumbers putty to seal.
Silicone
Sealant
Strainer
Gasket
Drain Ell
8. Insert the tailpiece into the trap inlet using the O-ring, coupling nut, & flange. The tailpiece may
need to be cut for proper fit. 1''-2'' of the tail piece shoudl fit inside the trap. Slip the flange over the tailpiece
and slide down to the floor.
O Ring
Coupling Nut
Flange
Trap Inlet
Tailpiece
Loading ...
Loading ...