IUN IN. TRU TIONS
for Even Heot Control Board
Electrll:at Shock Hazard
Disconmict power before servicing.
Failure to do so can result in deaUt or electrical shock.
|111 ii i _ I _q _ III El m| " i • ii
Even heat phase one was designed with an AC coil motor relay. Even heat phase two has a DC
coil motor relay.When replacing an avert heat phase one control board with this kit, the AC coil
motor relay must be replaced with the motor misy supplied in this kit,
1. Disconnect power or unplug dryer.
2. Remove the end cap trim on each end of the con.
sole.
3. Remove the screws in front of each end cap that
holds the console to the dryer top.
4. Flip console so the backside is facing you. See
Rgure 1.
5. Disconnect wires from the defect_ AC even heat
board, part number 3402605, and remove the board.
6. Disconnect the lout (4) wires, two (2) ptnWblack and
two (2) light blue, from the defeoUve AC coil motor
-slay, part number 697812, and remove motor m-
Ay.
7,
.
Remove console harness, that connects the rotary
swithes to the contorl board and the heat relay, part
number 3405990,
Cut two (2) pieces of tape on main harness by
motor relay. See Figure 1.
c0ml_. B0/_
R_I
.
10.
11.
12.
13.
14.
15.
Locate the two (2) pink/black wires from the main
harness that were connected to the AC motor relay.
One pink/blaok wire _0nnects to the control Ixiard,
other ;]oe,s into the body m me dryer0Tape the
pink/black wire that goes intot he body of the dryer
_to the main harness, IT WILL NuT _E U_i:u. See
Figure 2.
Install the new DC coil motor relay, part number
3405281, included in this kit..This relay is the same
as the DC coil heat relay. Attach the two (2) light
lue wi and th " k/black wire from
tacneo zO_r small terminal on the relay, and the
blue wires c_ be _acheo to eitm_-of the larger
terminals. Re-tape the main harness.
Install new DC even heat board, part number
3976594. Connect wires from main harness and
timer.
_nsole harness___2art number
39765_0 toe-th-e-€ontmiDoam, hiat relay, and the
rotary swltches.lnntali the aink/hlnrJc wire from t_
CLOllSOleharnA_ to the_remaining connector on the
motor relay,
Flip console into its original position.
Install screws into the end caps.
Attach the trim for the end caps.
OF_f
RG/L__
