Craftsman 917273753 lawn tractor

User Manual - Page 25

For 917273753.

PDF File Manual, 56 pages, Download pdf file

Loading ...
Loading ...
Loading ...
2. Connectone endof the BLACKcable
to the NEGATWE(-) terminal (C)of
fully charged battery.
3. Connectthe other end of the BLACK
cable(D) to good chassisground,
awayfrom fuel tank and battery.
TO REMOVECABLES,REVERSE
ORDER-
1. BLACKcablefirst from chassisand
then from the fully charged battery.
2. RED cablelast from both batteries.
02614
Weak or Dead Fully Charged
Battery Battery
REPLACING BATTERY
_WARNJNG: Do not short battery
terminals by allowing a wrench or any
other object to contact both terminals at
the same time. Before connecting battery,
remove metal bracelets, wristwatch bands,
rings, etc.
Positive terminat must be connected
first to prevent sparking from accidental
grounding.
1. Lift seat pan to raised position.
2. Disconnect BLACK battery cable first
then RED battery cable and carefully
remove battery from tractor.
3. Install new battery with terminals in
same position as old battery.
4. First connect RED battery cable to
positive (+) terminal with hex bolt and
keps nut as shown. Tighten securely.
Slide terminal cover over terminal
5. Connect BLACK grounding cable to
negative (-) terminal with remaining
hex bolt and keps nut. Tighten securely.
Positive
(Red)
Cable
TerminaJ
Cover
Negative (Black)
Cable
TO REPLACE HEADLIGHT BULB
1. Raise hood.
2. Pull butb holder out of the hole in the
backside of the grill.
3. Replace bulb in holder and push bulb
holder securely back into the hole in
the backside of the grill.
4. Close hood.
iNTERLOCKS AND RELAYS
Loose or damaged wiring may cause
your tractor to run poorly, stop running, or
prevent it from starting.
o Check wiring. See electrical wiring
diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 20 amp automotive-type
plugdn fuse. The fuse holder is located
behind the dash.
TO REMOVE HOOD AND GRmLL AS-
SEMBLY
1. Raise hood,
2. Unsnap headlight wire connector.
3. Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of
tractor.
4. When replacing hood, be sure to re-
connect the headlight wire connector.
Hood
Headlight Wire
Connector
Label
O2495 "
25
Loading ...
Loading ...
Loading ...