Loading ...
Loading ...
Loading ...
GEAppliances.com
WATER Possible Causes What ToDo
Too manysuds Type of detergent * Switch to a lower sudsing detergent brlmd and iollow
instructions on package.
Very soft water * Tr_ less deteroent
Too much detergent • Measure your deteigent carefilll> Use less soap i_you
have sod watec a smaller load or a lightly soiled load.
Water leaks Fill hoses or dram hose is • Make sure hose com_ections are tight at iimcets
improperly connected and at washel:
• Make sure end of drifin hose is properly connected
to washer and correctly inserted in and secured to
drain thcilit}.
Household drain may • (beck househokl plumbing. You may need to call a
be dogged plumbel:
Constant water pressure • Tighten hoses at tile fimcets and turn tile water off after
to the fill hoses at the each use.
water source • Check Colldifioil of tile fill hoses; tile) shoukl be
replaced e\ ery 5 years.
Using too much detergent • Use less detergent. Use less soap if you have sot{ water
in washer a smaller load or a lightly soiled load.
Water temperature Control is not set properly • Check water temperature control and a(!}ust.
is incorrect
Water supply is ttwned off • Ttlrll both hot and cold t_m(ets hill) on and make Stll'e
or improperly connected hoses are comlected to correct timcets.
Water valve screens are • Turn off the water source and disconnect _tei" fill
stopped up hoses fi'om tile upper back of tile _;Mler. LJsea brush or
toothpick to dean the screens ill tile madline, Recomaect
the hoses and mm tile x_tei" back on,
House water heater is * Make sm'e house water heater is delivering water
not set properly at 120°F-140°F (48°(2-60°(;).
PerlecTemp Plus feature * Tile lid must be closed fi)r Perlecremp Plusto work.
was not activated
Water pumped out Lid lifted or cycle was put in • Reset cycle.
before cycle is pause for over 24 hours
complete
Water won't drain Drain hose is _ed or • Str:fighten drain hose and make sure washer is not sitting
improperly connected on it.
• Top of dr:fin outlet should be less than 8 ft (2.5 m)
above flooY_
Water spraying during Washer in spin cycle • Spra} rinse during a spin (}cle is nomml.
spin cycle
Washer did not fill Extremely low water pressure * Press tile START button again.
to chosen level
(PeffecTemp Plus Inlet hoses axe ldnked * Straighten hoses.
and STARTlights
are flashing) Water valve screens are • Turn off the _Atel" source :rod disconnect _ttei" fill
stopped up hoses fi'om the upper back of the _asheI: Use a brush or
toothI)ick to dean the screens in tile inadline. Reconl_ect
tile hoses and tt*r/] the _ter back on.
Water fills and drains Drain stand pipe is too low • Drain stand pipe must be ab(we 30" (76.2 cm).
at the same time
17
Loading ...
Loading ...
Loading ...