Loading ...
Loading ...
Loading ...
' I
E
'jII
centerlJne
IIII Determine and clearly mark a
vertical centerline on the wall and cabinet
in the area the vent opening will be made,
Numbers
correspond
fo sfeps.
'1
'i I
i
i
i
i
i
!
i
i
centerlJne
2 It
from wall
(not cabinet
frame)
[]
To wire through fop, mark a line
7-1/2" from the right of the centerline on
the underside of the cabinet, Mark the
point on this line that is 2" from back wall,
Drill a 1-1/4" diameter hole through the
cabinet at this point, Note: If a cord-
connection kit is used, drill a 1-5/8"
diameter hole,
I
I
'1,
'11
L
I I
I
To wire through rear, mark a line 7-1/2" from
the right of the cenferline on the wall, Mark
the point on this line that is 65-1/4" from the
floor (or 3/4" from underside of cabinet),
Drill a ] -1/4" diameter hole through wall at
this point,
cabinet cutouts
I
l
I
I I
To make a 4"x 10-1/2" rectangle on the
underside of cabinet fop and bottom:
a. Mark lines 1-1/2" and 5-1/2" from the
back wall on the centerline of the
underside of cabinet,
b. Mark lines 5-1/4" to the right and left of
the centerline on the underside of
cabinet,
c. Use saber and keyhole saws to cut a
rectangular opening for vent,
d. Repeat steps a-c for the underside of
the top of the cabinet,
If venting through the wall with 3-1/4" x 10"
rectangular vent --
To make a 4"x 10-1/2" rectangle in the wall:
a. Measure from floor 65-7/8" and 62-3/8"
(or 1/8" and 3-5/8" down from underside
of cabinet) and mark on the cenferline
on the back wall,
b. Mark lines 5-1/4" to the right and left of
the cenferline on the underside of
cabinet,
c. Use saber and keyhole saws to cut a
rectangular opening for vent,
cabinet
5- '1/4"
* from wall, not
cabinet frame
To transition from a 3-1/4" x 10" rectangular
vent to a 7" round vent and vent through
the roof --
Start by making a 4"x 10-l/2" rectangle on
the underside of cabinet bottom:
a. Mark lines 1-1/2" and 5-1/2" from the
back wall on the cenferline of the
underside of cabinet,
b. Mark lines 5-1/4" to the right and left of
the cenferline on the underside of
cabinet,
c. Use saber and keyhole saws to cut a
rectangular opening for vent,
7-1/8'L-_,_ 7-5/8"
-'1-1/2"
*from
wall not
cabinet
frame
/
It
i
Now make a 7-1/8" x 7-5/8" slot on the
underside of the cabinet fops,
d. Mark lines 5" and 5-1/2" from the back
wall on the cenferline on the underside
of the fop of cabinet,
e. Draw two 7-1/8" circles using the marks
made in step d as center points,
f. Use saber and keyhole saws to cut a
slotted (oval) opening to make installing
7" round vent easier,
Panel C
Loading ...
Loading ...
Loading ...