Loading ...
Loading ...
Loading ...
9. PREPARING THE ATTACHMENTS
– When correctly adjusted it should be possible
manually run the chain around the bar and pull
one complete chain link clear of the groove.
9.3 CHAIN OIL (FIG.10)
– A continuous flow of oil on to the guide bar and
chain must be provided at all times. This oil
lubricates the chain around the bar preventing it
from over heating and seizing up.
– Turn the oil reservoir cap anticlockwise to
remove it.
– Fill the reservoir with chain oil. Do not use
any other type of new or used oil. Chain oil is
specifically designed for the job and is not
harmful to the environment.
– Replace the oil reservoir cap tightly, turning
it clockwise.
9.4 FITTING THE BRUSH CUTTER/GRASS
TRIMMER GUARD (FIG.11)
All guards must be fitted and fully operational
before using this machine.
– Snap the guard over the output shaft
collar .
– Drop the spring washer followed by the flat
washer over the end of the 5mm hex. socket bolt.
– One side of the the guard has a hexagon
shaped recess in which the 10mm nut sits.
– Pass the bolt through the guard from the other
side [guiding it under the curved end of bracket
and turn it clockwise to engage it with the nut.
– When the attachment is fitted the guard should
be position directly between the spool and your
legs. Using a 5mm hex. key tighten the guard so
that it does not move freely.
FIG. 9
FIG. 11
FIG. 8
17
FIG. 10
Loading ...
Loading ...
Loading ...