Frigidaire GLRT188WJW0 refrigerator

User Manual - Page 13

For GLRT188WJW0.

PDF File Manual, 13 pages, Download pdf file

Loading ...
Loading ...
Loading ...
1-800-944-9044 (United States) ] Visit our web site at
1=800=668=4606 (Canada) / www.frigidaire.com.
PROBLEM CAUSE _ CORRECTION
RUNNING OF REFRIGERATOR
Compressor does not run. Refrigerator control is set to
OFF.
Refrigerator is in defrost cycle.
Plug at electrical outlet is
disconnected.
House fuse blown or tripped
circuit breaker.
Power outage.
TEMPERA TURES ARE TOO COLD
Set refrigerator control. See Temperature Controls
section.
This is normal for a fully automatic defrost refrigerator.
The defrost cycle occurs periodically, lasting about 30
minutes.
Ensure plug is tightly pushed into outlet.
Check/replace fuse with a 15 amp time-delay fuse.
Reset circuit breaker.
Check house lights. Call local Electric Company.
Freezer temperature too Freezer control is set too cold. Set freezer control to a warmer setting. Allow 24 hours
cold. Fresh Food for temperature to stabilize.
temperature is satisfactory.
Fresh Food temperature Fresh Food control is set too Set fresh food control to a warmer setting. Allow 24
too cold. Freezer cold. hours for tern 3erature to stabilize.
temperature is satisfactory.
AUTOMATIC ICE MAKER
Ice maker is not making
any ice.
Ice maker is not making
enough ice.
Ice cubes are freezing
together.
WATER DISPENSER
Dispenser will not
dispense water,
Water pressure is
extremely low.
Ice maker wire signal arm is in
the "up" or OFF position.
Household water line valve is
not open.
Freezer is not cold enough.
Saddle valve on cold water
pipe is clogged or restricted by
foreign material.
Ice maker is producing less ice
than you expect.
Freezer is not cold enough.
Household water line valve is
not completely open.
Ice cubes are not being used
frequently enough.
Ice cubes are hollow (partially
frozen cubes with water
inside).
Move wire signal arm to the "down" or ON position.
(side mounted)
Turn on household water line valve.
Set freeze control to a colder setting. Allow 24 hours
for temperature to stabilize.
Turn off household water line valve. Remove valve.
Ensure that valve is not a self-piercing saddle valve.
Clean valve. Replace valve if necessary.
Ice maker should produce 2 1/2to 3 pounds of ice
every 24 hours.
Set freeze control to a colder setting. Allow 24 hours
for temperature to stabilize.
Turn on household water line valve.
Remove ice container and discard ice from container.
Ice maker will produce fresh supply.
The ice & water filter cartridge may be clogged.
Replace filter cartridge.
Household water line valve is
not open.
Freezer door is not closed.
Ice & water filter cartridge is
clogged.
Cut-off and cut-on pressures
are too low (well systems
only).
Reverse osmosis system is in
regenerative phase.
Open household water line valve. See PROBLEM
section ICE MAKER IS NOT MAKING ANY ICE.
Ensure that freezer door is closed.
Replace filter cartridge.
Have someone turn up the cut-off and cut-on pressure
on the water pump system (well systems only).
It is normal for a reverse osmosis system to be below
20 psi during the regenerative phase.
13