Loading ...
Loading ...
Loading ...
3
EnglIsh
ORIGINAL NUT
LEFT MOUNTING
BRACKET
REMOVE NUTS
FROM BOLTS
RIGHT MOUNTING
BRACKET
3/8" LOCK WASHER
(If new bolt and nut are needed)
(L)
3/8" FLAT WASHER
(TOP HOLE ONLY)
(M)
LIFT LEVER
ASSEMBLY
SLEEVE HITCH
FRAME ASSEMBLY
WELD
PIN
5/8" NYLOCK NUT
(H)
SPACER PLATE
(SEE NOTE)
(O)
HEX BOLT
5/8" x 1-3/4"
(B)
3/8" HEX NUT
(K)
3/8" LOCK WASHER
(L)
LEFT MOUNTING BRACKET
3/8" x 1-1/4"
HEX BOLT
RIGHT MOUNTING BRACKET
Step 4b: (fig. 4b)
If your tractor looks like figure 4B
1. Remove the nuts from the two bolt shown in each side
of the tractor, leaving the bolts in place.
2. Attach the Left Mounting Bracket (pin at top facing
in) to the bolts using the original nuts and a 3/8" flat
washer (M). Repeat for the other side.
NOTE: If no bolt and nut are present in a hole, use a 3/8" x
1-1/4" hex bolt (C), 3/8" lock washer (L) and 3/8" hex nut (K)
to attach the Mounting Bracket to the hole.
Step 5: (fig. 5)
1. Hook the Sleeve Hitch Frame assembly onto the weld
pins. Attached the bottom of the assembly to the tractor
hitch using a 5/8" x 1-3/4" hex bolt (B) and a 5/8" nylock
nut (H).
NOTE: If your tractor hitch has ridges that prevent the
sleeve hitch assembly from resting flat, place the spacer
plate (O) underneath the sleeve hitch assembly.
Step 6
1. Proceed to LIFT ASSEMBLY instructions on page 4.
Fig.4A
Fig.4B
Fig.5
917 ASSembLy
Step 4A: (fig. 4A)
If your tractor looks like figure 4A
1. Install two 3/8" x 1-1/4" hex bolts (C) in the left side of
the tractor as shown. Attach the Left Mounting Bracket
(pin at top facing in) to the bolts using two 3/8" lock
washers (L) and 3/8" hex nuts (K). Repeat on the right
side.
Loading ...
Loading ...
Loading ...