Loading ...
Loading ...
Loading ...
Installation Instructions
INSTALL THE RANGE
[] REPLACE THE WIRE COVER
Replace the wire cover on the range back
by sliding its left edge under the retaining
tabs and replacing the five screws removed
earlier. Make sure that no wires are pinched
between the cover and the range back.
R!! ____ !e c°ver
ai ing
I
Back of _ ' /
ANTI-TIP DEVICE INSTALLATION
An Anti-Tip bracket is supplied with
instructions for installation in a variety of
locations. The instructions include all
necessary information to complete the
installation. Read the Safety Instructions
and the instructions that fit your situation
before beginning installation.
Bracket_ Wall plate
orm
Typical installation of anti-tip bracket attachment to wall
WARNING:
• Range must be secured by Anti-Tip bracket
supplied.
• If the Anti-Tip device supplied with the
range does not fit this application, use the
universal Anti-Tip device WB2X7909.
• See instructions to install (supplied with bracket).
• Unless properly installed, the range could
be tipped by stepping or sitting on the door.
Injury may result from spilled hot liquids
or from the range itself.
[] PREPARE TO LEVEL MODELS
WITH BAKING OR WARMING
DRAWERS
[] Measure the height of your countertop
at the rear of the opening (X).
X
Y
[] Adjust two rear leveling legs so that the
rear of the cooktop is at the same height
as the counter (Y).
[] Slide unit into place.
[_] REMOVE STORAGE DRAWER
ON MODELS WITHOUT BAKING
OR WARMING DRAWERS
[] Pull the drawer out until it stops.
[] Lift the front of the drawer until the
stops clear the guide.
[] Remove the drawer.
8
Loading ...
Loading ...
Loading ...