Loading ...
Loading ...
Loading ...
9
Unpacking
• This product has been packaged to protect
it against transportation damage. Unpack
the appliance and remove all packaging
materials from around the rangehood. Keep
all packaging materials until you have made
sure your new rangehood is undamaged
and in good working order. The carton is
recyclable. Whenever possible, reuse the
carton and recycle it when disposing of
the packaging materials.
• Plastic wrapping can be a suffocation hazard
for babies and young children, so ensure all
packaging materials are out of their reach,
and dispose of them safely.
Important installation advice
WARNING!
• All electrical work associated with the
installation of this rangehood must be carried
out by a licensed electrician.
• This rangehood must be correctly installed by
a suitably qualifi ed person in strict accordance
with all applicable rules and regulations and
following the instructions in this manual.
• Do not try to install the rangehood yourself;
doing so will expose you to danger and void
the warranty. Improper installation, adjustment,
alteration or service can cause injury or
damage. We decline any responsibility for
injury or damage, to persons or property, as a
result of improper installation.
Before Installation:
Before Installation, please decide the extraction
mode with the adjuster on the motor (Fig. 1).
Fig. 1
DUCTING RECIRCULATING
Rangehood standard confi guration
This product has been supplied with
“recirculation mode” as the default setting.
The rangehood is suitable for both recirculation
(Fig 3.) and external ducting (Fig. 2) modes
Fig. 2 Fig. 3
External Outdoor Ducting Mode
Recommended wherever possible for optimal
performance
If you have chosen to operate your rangehood in
“External Outdoor Ducting Mode” you will need
to follow the steps below:
1. Unscrew the 80mm fascia rail which is already
installed on the rangehood (Fig. 4)
2. Using the same screws, attach the 40mm
fascia rail (part ID 3, Installation Kit) supplied
in the box
3. Remove the aluminium grease fi lters (Fig 6. on
page 10) from the underside of the rangehood.
Turn the switch in the centre of the motor
housing to “External Outside Ducting” position
(Fig. 1)
4. Remove the charcoal fi lters by twisting anti-
clockwise (Fig. 8 on page 11). The charcoal
fi lters are not required for “external outdoor
ducting mode”
5. Clip in the plastic Front Vent Cover (part ID 9,
installation kit) over the vent holes on the front
of the rangehood.
6. Using the screws provided, install the Flu
Outlet Adaptor (Part ID 10, Installation kit)
to the top of the rangehood
7. Install the ducting pipe (not supplied) to the
outlet on the top of the rangehood and
vent to external air. It is recommended that
the ducting pipe is 120mm in diameter.
Fig. 4
Loading ...
Loading ...
Loading ...