GE - General Electric TFX25ZPBEWW GE refrigerator - b series

User Manual - Page 14

For TFX25ZPBEWW.

PDF File Manual, 76 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Preparing to install the refrigerator.
Read these instructions completely and carefully.
Water Supply to the Icemaker(onsomomotions)
Ifthe refiigerator has an icemaker, it xdll have to be
connected 1o a cold water lille.
A water supply kit (containing copper tubing,
shutoffvalve, fittings and insu_ucfions) is available
at exua cost flom your dealer or fiom Parts and
Accessories, 800-626-2002.
RefrigeratorLocation
Do not install the refligera/or where tile
temperature will go below 60°F (16°C)
because it will not run often enough to maintain
proper temperatures.
Install it on a floor strong enough to support it
flflly h)aded.
Clearances
Allow the folh)xdng clearances for ease of
installation, proper air cir(ulation and
plumbing and elecui(al (onne(dons:
Sides ,)/8 (ID IIlIIl)
Top 1" (25 IllIll)
If built-in, allow 7/8" {22 ram) for hinge covers.
If the refiigerator is against a w:tll on either side,
allow the tblh)wing door clemances:
20', 22', and 24'models 3/4" (19ram)
27' models 17Z' (38 ram)
Back 1" (25 IIllI1)
Rollers
The milers have 3 purposes:
[_] Rollers a(!just so the door ch)ses easilywhen
opened about halfivay. [Raise the fiont about
,) _ (15 ram) fiomthetloor.]
To assure that tile doors will close m_tomatically
tiom a halt_xW open position, there is a buih-in tilt
fiom the flont to the back of the cabinet. Side-b)=
side retiigerators also have spedally designed door
hinges that lift both doors slightly when opened,
allowing the torce of gravity to help close them
se(urely.
[_ Rollers adjust so tile refiigerator is firmly
positione(i on tile floor and does not wo])ble.
_] Rollers allow you to move tile refiigerator away
Y
fi'oln the wall}br (leaning.
Toadjustthemilers,remove tile base grille by pulling
it out at tile bottom.
Turn the roller ac!iusting screws clockwiseto raise
tile refiigerator, counterclockwiseto Iowerit. Usean
ac!iustable x_Tench (3/8" hex head 1)oh) or pliers.
7"0replace base grille, align prongs on back of grille
wifll (lamps in (abinet and push forward until grille
snaps into pla(e.
/4
Loading ...
Loading ...
Loading ...