Danby DR241WGLP Designer 3 cu.ft. Range

4. SEAL THE OPENINGS

Seal any openings in the wall behind the range and in the fl oor under the range when hookups are completed.

5. IF THE RANGE HAS ELECTRIC IGNITION

There are separate ignition devices for the left and right hand surface burners. Both of these ignitors are ON when any

knob is turned to the LITE setting. The ignitors will spark as long as any of the top burner knobs are at the LITE setting.

In the event of an electrical power failure, the top burners can still be used. To light a burner, hold a lit kitchen match adja-

cent to the top burner to be used and turn valve knob to LITE. USE EXTREME CAUTION.

the burner ports. If lifting is observed, gradually reduce the air shutter opening until fl ames are stabilized. Some yellow

tipping may be normal for LP gas.

If Adjustment is Necessary:

A: Loosen the lock screw located at the top of the air shutter, then rotate the air shutter to the correct setting and retighten

the screw.

B: Oven burner fl ame can be checked as follows (without burner baffl e in place)

• To correct a yellow fl ame, increase size of air shutter opening

• To correct a lifting, but distinct, blue fl ame - Decrease size of air shutter opening.

C: The air shutter should be set approximately 2/3 open for natural gas, and approximately full open for LP gas.

D: The oven burner air shutter adjustment is the same on ranges with a gas pilot or electric ignition.

Bake/broil

Loosen lock

screw

30