Loading ...
Loading ...
Loading ...
Operation
50
Starting a program
The dishwasher can be started only if
the door is closed.
Press the Start sensor button.
The program starts, and the prompt
Dishes can be added appears in the dis-
play.
As long as this prompt is showing,
dishes can be added without compro-
mising the wash results.
Water in the dishwasher may be
hot. Danger of scalding from water in
the cabinet.
Make sure you open the door very
carefully.
A program should only be canceled
in the first few minutes, if at all. Oth-
erwise important program stages
could be omitted.
Time display
The estimated duration of the program
selected appears in hours and minutes
in the display before the program be-
gins. During the program, the time left
until the end of the program is dis-
played.
Each program phase is indicated by a
symbol:
Pre-wash / Soak
Wash
Interim rinse
Rinse cycle
Drying
Finish
The program duration displayed may
vary with the same program. It is influ-
enced by, among other things, the wa-
ter temperature at each intake, the re-
activation process, the softener assem-
bly, the type of detergent, the amount
of dishes, and the amount of soiling.
When a program is selected for the first
time, the display will show the average
program duration for a cold water in-
take.
The times shown in the program over-
view refer to standard test loads and
temperatures.
Each time a program is run, the elec-
tronic module calculates the program
duration required depending on the
temperature of the water taken into the
dishwasher and the amount of dishes.
Loading ...
Loading ...
Loading ...