Loading ...
Loading ...
Loading ...
@
Wipe dipstick clean.
Pour oil from enclosed bottle into the oil fill opening
until oil reaches FULL mark on the dipstick. Stop and
check the oil level periodically. DO NOT OVERFILL.
Install oil dipstick, hand tighten securely.
ADD GASOLINE
WARNING NEVER fill fuel tank indoors.
NEVER fill fuel ta'nk when engine is running
or hot. DO NOT light a cigarette or smoke
when filling the fuel tank.
_1_ AUTION: Do not overfill the fuel tank.
Always leave room for expansion.
Use regular UNLEADED gasoline withthe pressure
washer engine. Regular leaded gasoline may also be
used if UNLEADED is not availabte. Fuel tank capacity
is 1 U.S. quart.
IMPORTANT: It is important to prevent gum deposits
from forming in essential fuel system parts such as the
carburetor, fuel filter, fuel hose or tank during storage.
Also, experience indicates that alcohol-blended fuels
(called gasohot, ethanol or methanol) can attract moisture
which leads to separation and formation of acids during
storage. Acidic gas can damage the fuel system of an
engine while in storage. To avoid engine problems, the
fuel system should be emptied before storage of 30 days
or longer. See "Storage" on page 14. Never use engine or
carburetor cleaner products in the fuel tank or permanent
damage may occur.
• Clean area around fuel fill cap, remove cap.
• Add "UNLEADED" regutar gasoline, slowly, to fuel
tank.
• Install fuel cap and wipe up any spilled gasoline.
TO START YOUR PRESSURE WASHER
You have assembled your high pressure washer and
have prepared the engine for starting, You are now ready
to clean your car, boat or the outside of a building or
whatever you plan to clean.
o
Place the pressure washer in an area close enough to
an outside water source that can flow at a rate of 3
gallons per minute. Connect a garden hose to the
water spout.
Check that the high pressure hose istightlyconnected
to the spray gun and to the pump. See ASSEMBLY
section for illustrations.
Remove the female quick-connect from pump. Check
inlet screen. If the screen is dirty, clean before
attaching to garden hose. If the screen is damaged,
Do not connect to the garden hose. Call the pres*
sure washer customer helpline to order a replace-
ment.
Attach the female quick-connect to garden hose and
then attach the garden hose to the water inlet. Push
until you hear the quick-connect "click,"
MALE_.
CONNECTOR
GARDEN
HOSE_
Turn on the water.
Set Throttle Control Lever to RUN position.
Remove the wand extension and squeeze the trigger
to purge pump system of air and impurities then
engage the safety latch on spray gun by pushing lever
upward toward the top of the handle. This disables the
trigger so you cannot inadvertently actuate a high
pressure spray, z_
Loading ...
Loading ...
Loading ...