Loading ...
Loading ...
Loading ...
17
On portable models, this shelf, in the upright position,
is to be used as a handle to move the barbecue
around. It is a sturdy handle properly hinged securely
into place (see Fig. 31).
Figure 31
FINISH ASSEMBLY
1. Be sure to remove all plastic protective film.
Place rock grate in the bottom of the casting.
2. Place ceramic "Moon Rok II" on rock grate by
evenly placing side by side. See figure 32
Figure 32 Proper placement of rock grates and "Moon ROK”
and Cooking Grids
3. Place lid on lower casting. Insert hinge pins
through top lid casting, then through pre-drilled hole in
lower casting and attach cotter pins through hole in
hinge pins to secure top to bottom casting
(see Fig. 33).
Figure 33 Hinge Pins/Cotter Pins
5. Attach twin lid sides "Stay Cool" handles using
5/16" X 3/4" bolt and star washer, tighten securely.
6. Be certain that grease cup is secure in back of
column.
7. Attach two control valve knobs to end of valve
stems located in center of control panel. White mark
should be pointing up to the OFF position.
LIGHTING YOUR GRILL
BEFORE ATTEMPTING TO LIGHT YOUR
GRILL, INSPECT THE HOSE OR GAS
SUPPLY. If it is evident there is excessive
abrasion or wear, or the hose is cut, it must be
replaced prior to the grill being operated. Please
contact your local dealer/distributor for an exact
replacement hose.
ALWAYS OPEN THE LID COMPLETELY BEFORE
LIGHTING THE BURNER. This is to avoid trapping
gas fumes, which could ignite. Do not stand with your
head over the grill when lighting the burner.
✓ Open the lid. Examine the interior to be sure it
appears normal.
✓ Turn control knobs to OFF position. Either control
knob may be used when lighting your PGS gas
grill.
✓ Turn gas ON at tank or supply.
✓ Turn either knob to Medium and gently push the
red button on control panel ignitor module. You
should hear the ignitor clicking and one half of the
burner should be lit within four seconds. Turn the
other control knob on “HI” and the other burner
will cross light automatically.
✓ Visually verify that the burner lights and the flame
is acceptable. Close the grill top and let the
ceramic rocks get hot. Pre-heat the grill on HI
with the lid down for five to seven minutes. This
will ensure even heat and allow cooking at
MEDIUM, for the most part.
WE STRONGLY SUGGEST OBSERVING GRILL
FOR TWO MINUTES BEFORE LEAVING.
SMALL LEAKS AND OR SPIDER FIRES CAN
EASILY BE REMEDIED IF CAUGHT
IMMEDIATELY.
IF THE BURNER FAILS TO LIGHT
Immediately turn controls OFF to prevent gas build-
up. Wait five minutes for gas to clear and try the
above procedure again. If the burner does not light
with the electronic ignition, light the burner with a
match or other hand held ignitor. On the right hand
side of the lower grill casting, near the bottom, there is
a match lighting hole (see Fig. 34). Raise the grill lid.
Loading ...
Loading ...
Loading ...