Loading ...
Loading ...
Loading ...
or su
8, Should any part of this scrollsaw bt
fail in any way, or any
perform properly, shut off and remove
plug from power supply outlet. Replace damaged,
missing, and/or failed parts before resuming opera-
tion.
9. Think Safety.
Safety is a combination of operator common sense
and alertness wheneverthe scroll saw isin operation.
The operation of any power tool ca_ result in foreign
objects being thrown into the eyes, which can result in
severe eye damage. Always wear safety goggles
complying with ANSI Z87.1 (shown on Package) before
commencing power tool operation. Safety goggles are
available at Sears retail or catalog stores.
WARNING: ALWAYS KEEP ALERT. DO NOT AL-
LOW FAMILIARITY (GAINED FROM FREQUENT USE
OF YOUR SCROLL SAW) TO CAUSE A CARELESS
MISTAKE. ALWAYS REMEMBER THAT A CARE-
LESS FRACTION OF A SECOND IS SUFFICIENTTO
INFLICT SEVERE INJURY,
f
/ FOR YOUR OWN SAFETY: \
Read and understand owner's
manuat before operating SCroll Saw.
B ALWAYS wear SAFETY GOGGLES
complyingwith ANSI Z87,1.
o PROPERLY ADJUST HOLDDOWN,
= Hold workpiece down firmly,
o Turn sawoff and LOCK SWITCH
before adjusting saw, changing
bladeor leaving area.
• When INSTALLING BLADE: Blade
teeth must point down, Tension
blade by turning knob clockwise
one full turn beyond take-up of
alack. Fol!ow ©omplnte installation
and checking procedure in owner's
60 Hz AC oaty, 1.2 empm EI_'_
electrical connections
3-PRONG PLUG
WARNING: TO AVOID ELECTRICAL HAZARDS, FIRE
HAZARDS, OR DAMAGE TO THE TOOL, USE
PROPER CIRCUIT PROTECTION. YOUR SAW IS
WIRED AT THE FACTORY FOR 120V OPERATION.
CON NECT TO A 120-V, 15-AMP, BRANCH CIRCUIT
AND USE A 15-AMP FUSE OR CIRCUIT BREAKER.
TO AVOID SHOCK OR FIRE, IF POWER CORD IS
WORN OR CUT, OR DAMAGED IN ANY WAY, HAVE
IT REPLACED IMMEDIATELY.
\
GROUNDING PRONG
PROPERLY GROUNDED
3-PRONG OUTLET
IFNOT PROPERLY GROUNDED THIS POWER TOOL
CAN CAUSE ELECTRICAL SHOCK- PARTICULARLY
WHEN USED IN DAMP LOCATIONS CLOSE TO
PLUMBING, IF AN ELECTRICAL SHOCK OCCURS
THERE IS ALSO THE POTENTIAL OF A SECON-
DARY HAZARD SUCH AS YOUR HANDS CONTACT-
ING THE SAWBLADE. NOT ALL OUTLETS ARE
PROPERLY GROUNDED. IF YOU ARE NOT SURE
THAT YOUR OUTLET IS PROPERLY GROUNDED,
HAVE ITCHECKED BYA QUALIFIED ELECTRICIAN.
'(our unit has aptug that looks like the one shown.
The ground conductor has a green jacket and is at-
tached to the tool housing at one end and to the ground
prong in the attachment plug at the other end.
Thisplug requires a mating 3-conductor grounded type
outlet as shown above.
WARNING: TO MAINTAIN PROPERTOOLGROU hiD-
INGWHENEVERTHE OUTLETYOU ARE PLANNING
TO USE FOR THIS POWER TOOL IS OF THE TWO
PRONG TYPE, DO NOT REMOVE OR ALTER THE
GROUNDING PRONG IN ANY MANNER. USE AN
ADAPTER AS SHOWN AND ALWAYS CONNECT
THE GROUNDING PRONG TO KNOWN GROUND.
, ii
4
Loading ...
Loading ...
Loading ...