Loading ...
Loading ...
Loading ...
i
removing and nst
1. Unplug power cordfrom outlet.
2. Loosen tension on blade by turning tension knob
counterclockwise about four full turns. Loosen the
hex screw of blade holder and push it toward left di-
rection.
3. Support the blade holder by using the "U" shaped bar
provided in the darts bag,
4. Slip one side of bar behind the holder while the other
side isplaced through the hole provided in front of the
blade holder.
i
ng binaries
TENSION KNOB
_J
f
"'U'SHAPED BAR
\
J
7
J
SCREW
5. Loosen the lower blade holder screw in the same way
you Ioosened the upper blade holder in Steps 2 & 3.
Remove blaae by pulling forward on blade and then
lifting the blade through the access hole in the table.
LOOSEN LOWER
BLADE HOLDER
SCREW
6. Prior to installing blade, make sure the teeth of the
blade point down.
UPPER
BLADE HOLDER
Look at the lower blade holder closely, installthe new
blade through the access hole of the table into the
lower blade holder. With hex "L" wrench, lasten the
lower blade holder, but not completely tight. The_
install the U-shaped bar intothe upper blade holder,
push the blade into the upper blade holder, and
tightenthe screw ofthe upper blade holder. Using the
.... sametechnique tighten the screw ofthe lower blade _'_
: holder again_ : Fina!ly ipiace tension on blade by
:i iurning tension knob €l_kwise after U_shaped bar
_ ___ HOLDER
Loading ...
Loading ...
Loading ...