Loading ...
Loading ...
Loading ...
Installation
PREPARATION
NOTE: All the illustrations in the manual are for explanatory purposes only. Your
machine may be slightly dierent. The unit can be controlled by the control panel or
with the remote control.
EXHAUST HOSE INSTALLATION
The exhaust hose and adaptor must be installed or removed in accordance with the
set MODE. For COOL & DRY MODE the exhaust hose must be installed. For FAN
only mode the exhaust hose should be removed.
EXHAUSTING HOT AIR
In COOL MODE the appliance must be placed close to a window or opening so that
the warm exhaust air can be expelled outside.
CHOOSING THE RIGHT LOCATION
Your installation location should meet the following requirements:
• Make sure that you install your unit on an even surface to minimize noise and
vibration.
• The unit must be installed near a sucient power outlet, and if using a continuous
drainage method, then the plug areas should be accessible.
• The unit should be located at least 45cm from the nearest wall to ensure proper
air conditioning. The horizontal louver blade should be at least 50cm away from
obstacles.
• The exhaust hose can be extended, however it's best to keep it to the minimum
length required. Ensure the hose doesnt have any sharp bends, sagging areas or
kinks
• DO NOT cover the Intakes, outlets or remote control signal receptor of the unit,
as this could cause damage to the unit.
14
Loading ...
Loading ...
Loading ...