Loading ...
Loading ...
Loading ...
- 7 -
5. HEALTH AND SAFETY INFORMATION
Wait for the machine to stop. Unless the machine is fitted with a safety brake, some parts may
continue to move due to momentum. Wait for all parts to stop, then unplug it from the power supply
before making any adjustments, carrying out maintenance operations or just finishing using the tool.
Remove and check setting tools. Some machinery requires the use of additional tools or keys to
set, load or adjust the power tool. Before starting the power tool always check to make certain they
have been removed and are safely away from the machine.
Prevent unintentional starting. Before plugging any machine in to the power supply, make sure the
switch is in the OFF position. If the machine is portable, do not hold the machine near the switch and
take care when putting the machine down, that nothing can operate the switch.
Carefully select an extension lead. Some machines are not suitable for use with extension leads. If
the tool is designed for use outdoors, use an extension lead also suitable for that environment. When
using an extended lead, select one capable of handling the current (amps) drawn by the machine in
use. Fully extend the lead regardless of the distance between the power supply and the tool. Excess
current (amps) and a coiled extension lead will both cause the cable to heat up and can result in fire.
Concentrate and stay alert. Distractions are likely to cause an accident. Never operate a power tool
if you are under the influence of drugs (prescription or otherwise), including alcohol or if you are
feeling tired. Being disorientated will result in an accident.
Have this tool repaired by a qualified person. This tool is designed to conform to the relevant
international and local standards and as such should be maintained and repaired by someone
qualified, using only original parts supplied by the manufacturer. This will ensure the tool remains safe
to use.
IMPORTANT
If using an extension lead, follow the instructions that came with your lead regarding
maximum load while cable is wound. If in doubt, ensure that the entire cable is unwound.
Using a coiled extension lead will generate heat which could melt the lead and cause a fire.
5.2 ADDITIONAL SAFETY INSTRUCTIONS FOR WEED BURNER USE
NOTE: A FIRE COULD ARISE IF THIS WEED BURNER IS NOT USED WITH CARE.
1. Ensure that the weed burner is switched OFF before connecting to the power supply.
2. Do not use this weed burner as a hair dryer.
3. Do not touch the hot metal cone.
4. Always allow to cool gradually by turning to the lower setting (“1”) for 1 minute after each use.
5. Place the weed burner on its standing position after use and allow it to cool down before
storing it away.
6. Do not attempt to cool by immersing in water.
7. Do not direct the flow of hot air at persons or animals.
8. Do not hold the metal cone too close to the ground as the air flow will be restricted and may
cause the weed burner to overheat. For best results hold the head 10 - 50mm above the
target weed.
9. Hold the weed burner in place for approximately 3 seconds until the weed becomes blackened
and shrivelled. Larger, more stubborn weeds may need multiple applications.
10. Suitable for outdoor use only.
11. Not suitable for commercial use.
12. Do not use in wet or windy conditions.
13. Always remain a safe distance from evergreens, pine needles, and all conifers. Highly
flammable and easily ignited, pine needles are a fire hazard.
14. Never leave the weed burner running whilst unattended.
15. Do not look directly into the metal cone when the machine is switched on.
Loading ...
Loading ...
Loading ...