Loading ...
Loading ...
Loading ...
THE LASER BEAM
i,_ WARNING ]
For your own safety, never connect
the plug to power source outlet
until all the adjustment steps
are complete and you have read
and understood the safety and
operational instructions.
Your tool is equipped with the Laser
Trac ®cutting guide using Class II laser
beam. The laser beam will enable you
to preview the saw blade path on the
stock to be cut before starting the miter
saw. This laser guide is powered by the
transformed alternating current supply
directly through the power lead. The
saw must be connected to the power
source and the laser on/off switch must
be turned on for the laser line to show.
j,AWARNING]
AVOID DIRECT EYE CONTACT
o Laser is radiated when laser
guide is turned on. Avoid direct
eye contact. Always un=plug the
miter saw from power source
before making any adjustments.
o Laser Warning Label: max
output <1 mW DIODE LASER:
630=670nm, Complies with
21CFR 1040.10 and 1040. 11.
Class II laser product.
LASER RAO_AT*ON
oo NOTSTAR__NTO_A_
MAXOUTPUT• _W 0_OO__AS_R630670._,
_ CL_,SS!!LAS_ PROOUCTj
NOTE: All the adjustments for the
operation of this machine have
been completed at the factory.
Due to normal wear and use, some
occasional readjustments may be
necessary.
CAUTION=Use of controls or
adjustments or performance of
procedures other than those
specified herein may result in
hazardous radiation exposure.
CAUTION=The use of optical
instruments with this product
will increase eye hazard.
Do not attempt to repair or
disassemble the laser, if
unqualified persons attempt
to repair this laser product,
serious injury may result. Any
repair required on this laser
product should be performed
by authorized service center
personnel.
BEVEL STOP ADJUSTMENTS
(FIG. N, O, P)
i WA..I.G1
To avoid injury from unexpected
starting or electrical shock, make
sure the trigger is released and
remove the power cord from the
power source.
900(0°) Bevel adjustment (Fig. N)
1. Loosen bevel lock handle (1) and
tilt the cutting arm completely to the
right. Tighten the bevel lock handle.
2. Place a combination square (2) on
the miter table with the ruler against
the table and the heel of the square
against the saw blade.
3. If the blade is not 90 ° (0°) square
with the miter table (5), loosen the
bevel lock handle (1), tilt the cutting
head to the left, loosen the Iocknut
(4) on the bevel angle adjustment
bolt (3) and use a 10 mm wrench
22
Loading ...
Loading ...
Loading ...