Loading ...
Loading ...
Loading ...
page 4
5. Fan Assembly.
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Lower hanging
ball and remove stop pin and then slide hanging ball
off of the downrod. [Refer to diagram 1.]
Loosen yoke set screws and nuts at top of motor
housing. Remove pin and clip from motor housing
yoke. [Refer to diagram 2.]
Tip: To prepare for threading electrical wires through
downrod, apply a small piece of electrical tape to the
ends of the electrical wires--this will keep the wires
together when threading them through the downrod.
[Refer to diagram 2.]
Determine the length of downrod you wish to use.
Thread safety cable and electrical wires through
threaded end of downrod and pull extra wire slack
from the upper end of the downrod.
[Refer to diagram 2.]
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes in
yoke--make sure wires do not get twisted. Re-insert pin
and clip that were previously removed. Tighten yoke
set screws and nuts securely. [Refer to diagram 2.]
Locate canopy cover in hardware pack. Slide yoke
cover, canopy cover and canopy over downrod. [Refer
to diagram 3.] (Note: Canopy cover must be turned
with shiny side toward motor housing. )
Thread safety cable and wires through hanging ball;
then slide hanging ball over downrod--the top of the
downrod should be noted as having a set screw hole;
use this hole when setting the set screw. Insert stop pin
into top of downrod and raise hanging ball. Be sure
stop pin aligns with slots on the inside of the hanging
ball. Tighten set screw securely. [Refer to diagram 4.]
Lower yoke cover to motor housing.
WARNING: Failure to tighten set screw on hanging ball
completely could result in the fan becoming loose and
possibly falling.
["Fan Assembly" continued on next page.]
set screw
hanging ball
stop pin
diagram 1
diagram 3
diagram 2
yoke set
screw
and nut
pin
clip
downrod
electrical wiring
safety cable
canopy
motor
housing
downrod
yoke cover
canopy cover
NOTE: The important safety precautions and instructions
appearing in the manual are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense and caution are necessary
factors in the installation and operation of this fan.
diagram 4
set screw hole
set screw
hanging ball
canopy
stop pin
Loading ...
Loading ...
Loading ...