Loading ...
Loading ...
Loading ...
4
Preparations for Installation
Before you begin, make sure you have all the parts and tools necessary for installation.
Tools You May Need:
• Flat Screwdriver or Putty Knife • Phillips Screwdriver • Tape Measure • Level • Drill
Parts Supplied:
Note: You may need to contact an electrician if your room’s circuit is not able to power your unit.
Note: To avoid risk of injury and / or product / property damage, please take the following
precautions:
• Two or more people are needed to properly handle and install the unit.
• Use proper lifting and carrying techniques.
• Before installation, make sure to inspect the installation location to ensure it is able to handle
the weight and size of this unit.
• Wearing protective gloves will help to avoid injury from sharp edges.
The parts below are intended to be used in conjunction with a Koldfront branded Wall
Sleeve (WTCSLV).
Part Name
Size
Qty Included
Horizontal Insulation Seals
1” x
3
/
8
” x 25”
1
Vertical Insulation Seals
1” x
3
/
8
” x 14”
2
Horizontal Insulation Seals
1” x
3
/
4
” x 14”
2
Foam Support Blocks
1” x 1
1
/
2
” x 14”
2
Tapered Support Blocks
1” x 1” x 17” (tapered to ¾”)
2
Main Insulating Seal (stuffer seal)
1” x 1
1
/
2
” x 84”
1
Trim Frame (sides)
2
Trim Frame (top / bottom)
2
Ground Wire (green)
1
Toothed washers for grounding screw
2
Grounding Screw
1
Rear Louver Panel / Grille (aluminum)
1
Nuts (plastic)
4
Washers (for screws)
4
Screws
4
Additional and / or duplicate parts noted below have been included to allow for installation
into non-Koldfront branded Wall Sleeves or to accommodate non-standard installation
scenarios. Any unused parts may be discarded at your discretion.
Part Name
Size
Qty Included
Centering / Support Blocks
4
1
/
2
” x 3
1
/
2
” x1
1
/
2
”
4
Plastic Divider
1
/
8
” x 4
1
/
2
” x 14
1
/
2
”
2
Horizontal Insulation Seals
1” x
3
/
8
” x 25”
2
Horizontal Insulation Seals
1” x 1
1
/
2
” x 25”
3
Loading ...
Loading ...
Loading ...