Loading ...
Loading ...
Loading ...
HOWTO STOP YOUR UNIT
• To stop the engine, move the ON/OFF
switch to the OFF position.
_J
_r_j._ Switch
HOW TO START YOUR UNIT
WAR NIN G: Avoid any contact with the
muffler. A hot muffler can cause serious bums.
Starting position
HELPFUL I
!f your engine still does not
I start after following these I
instructions, pleas e Call
1-800-554-8723.
STARTING A COLD ENGINE
NOTE: DO NOT squeeze the throttle trigger
until the engine has started and runs.
1. Set unit on a flat surface.
2. Move ON/OFF switch to the ON position.
3. Slowly press the primer bulb 6 times.
4. Move the start lever to the START posi-
tion.
Primer Bulb
Start Lever
STARTING A WARM ENGINE
1. Move ON/OFF switch to the ON position.
2. Squeeze and hold the throttle trigger.
Keep throttle trigger fully squeezed until
engine runs smoothly..
3. Pullstarter rope sharply while squeezing
throttle trigger until engine runs.
NOTE: Normally, the warm starting proce-
dure can be used within 5-10 minutes after
the unit is turned OFR if the unit sits for more
than 10 minutes without being ran, it will be
necessary to start the unit by following the
steps under STARTING A COLD ENGINE or
following the starting instruction steps shown
on the unit.
STARTING A FLOODED ENGINE
Flooded engines can be started by p_acing
the ON/OFF switch in the ON position. Move
the start lever to the RUN position and fully
squeeze throttle trigger. Pull the starter han-
dle repeatedly while squeezing throttle trigger
until engine starts and runs. This could re-
quire pulling the starter handle many times,
depending on how badly the unit is flooded.
If the unit still doesn't start, refer to
TROUBLESHOOTING TABLE or call
1-800-554-6723.
OPERATING THE COUPLER
This model is equipped with a coupler which
enables optional attachments to be installed.
The optional attachments are:
MODEL:
Edger ..................... PP1000E
Cultivator .................. PP2000T
Blower .................... PP3000B
Pruner .................... PP5000P
'_ WARNING: Always stop unit and dis-
connect spark plug before removing or instal-
ling attachments.
REMOVING TRIMMER ATTACH-
MENT (OR OTHER OPTIONAL
ATTACHMENTS)
CAUTION: When removing or installing at-
tachments, place the unit on a flat surface for
stability.
1. Loosen the coupler by turning the knob
counterclockwise.
Upper Shaft
Coupler
Lower
Attachment
Starter Handte
5. Pull starter rope handle sharply until en-
gine starts and runs.
6. Allow unit to run for 10-15 seconds, then
fully squeeze the throttle trigger to disen-
gage the starting system.
TIGHTEN Knob
2. Press and hold the locking/release button.
Loading ...
Loading ...
Loading ...