Loading ...
Loading ...
Loading ...
installation
14 TROUBLE SHOOTING Chef 540 Upright Cooker
Location
This appliance must not be placed on a base. This appliance
must not be installed behind a decorative door.
The appliance has been designed to fit a 550mm gap in kitchen
cabinetry or have free space on either side. Ensure the top of the
hotplate is at least 10mm higher than the level of the benchtop.
Electric hob models must not be installed in a corner; they must
be installed at least 100mm from the side wall.
Gas hob models must be installed with a minimum clearance of
100mm to side walls made of unprotected combustible material.
For gas models, refer to section 6.10.1 in AS/NZS 5601.1 for all
relevant clearance.
Clearance to
side wall
(refer notes
above)
600mm min.
to combustible
material
550mm
min.
1150 mm
910mm
540mm
620mm
Anti-tilt plate
1.25m electrical
service cord (if fitted)
WARNING
warning
In order to avoid accidental tipping of the appliance
(for example, by a child climbing onto the open oven door),
the anti-tilt plate and stabilising bolt MUST be installed.
Position anti-tilt plate to the rear wall and 25mm from side of cupboard.
Securely fix anti-tilt plate to the floor with fasteners. Adjust levelling
feet on cooker as required.
Stabilising bolt
Stability
bolt
Kick-panel
6.5mm ø drilled
location hole
Front
adjustable
feet
1. Remove oven door – to be done by qualified personnel only.
(Refer to procedure).
2. Remove screws from kick panel. To remove kick panel lift kick
panel upwards to release the two location tabs from the holes
in the bottom of the panel.
3. Position cooker into the ant-tilt plate and then mark the position
for the stability bolt hole on the floor.
4. Pull cooker out and drill the bolt hole, using a 6.5mm masonry
or wood drill bit. The bolt hole needs to be a minimum
of 30mm deep when fixing the oven to concrete.
5. Reposition cooker back into place and fit the stability
bolt through the slot and into the drilled hole.
6. If the cooker is placed on a base, measures must be
taken to prevent the appliance slipping from the base.
7. Carefully remove any protective plastic film to prevent damage
to the appliance.
WARNING
warning
For your safety this cooker is designed to be moved out of position
by a qualified person only.
Rear cover
25mm to side
of bracket
Rear adjustable foot
Cooker
width
540mm
Anti-tilt plate
5mm clearance
Loading ...
Loading ...
Loading ...