Loading ...
Loading ...
Loading ...
EN / 39
If the product fails to drain water inside it, the
pump filter is clogged. Filter must be cleaned
whenever it is clogged or in every 3 months.
Water must be drained off first to clean the
pump filter.
In addition, prior to transporting the product
(e.g., when moving to another house) water
should be drained completely.
NOTICE:
Foreign substances left in the pump
filter may damage your product or
may cause noise problem.
In regions where freezing is possible,
the tap must be closed, system
hose must be removed and the wa-
ter inside the product must be
drained when the product is not in
use.
After each use, turn off the tap to
which the mains hose is connected.
In order to clean the dirty filter and drain
the water:
a. Unplug the product to cut off the supply
power.
Temperature of the water inside the
product may rise up to 90 ºC. To
avoid the risk of scalding, clean the
filter after the water inside the
product is cooled down.
b. Open the filter cover.
c. Follow the below procedures in order to
drain water.
If the product has an emergency water
draining hose, in order to drain the wa-
ter:
• Pull the emergency draining hose out of its
seat.
• Place the end of the hose in a large con-
tainer. Drain the water into the container
by pulling out the plug at the end of the
hose. When the container is filled, close
the end of the hose with the plug. Drain all
water by repeating the procedure spe-
cified above after draining the container.
• When the water drain is finished, close the
end with the plug again and fix the hose in
its place.
• Unscrew the pump filter.
a. Clean any residues inside the filter as well
as fibres, if any, around the pump im-
peller region.
b. Replace the filter.
c. If the filter cap is composed of two
pieces, close the filter cap by pressing on
the tab. If it is one piece, seat the tabs in
the lower part into their places first, and
then press the upper part to close.
8 Troubleshooting
Please read the “Safety Instructions”
section first!
Programmes do not start after the load-
ing door is closed.
• Start / Pause /Cancel button might not be
pressed. >>> * Press the Start / Pause /
Cancel button.
Loading ...
Loading ...
Loading ...