Loading ...
Loading ...
Loading ...
Assembly (continued)
Before beginning assembly of product, make sure all parts are present. Compare parts
with package contents list and diagram, if any part is missing or damaged, do not
attempt to assemble the product. Contact customer service for replacement parts.
A Philips head screw driver is required.
,_ WARNING: Do not plug in power cord to power outlet, make sure plug is
disconnected before assembling the wet/dry vac.
UNPACKING YOUR WET/DRY
VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is
disconnected from the outlet. (Fig. 1)
2. Undo the latches. (Fig. 2)
3. Lift the power head off the collection
tank. (Fig. 3)
4. Remove the contents from inside the
collection tank, make sure you have
all contents as listed on page 5.
(Fig. 4)
5. Turn the collection tank upside down
and insert the two casters into the
slots on the front side of the collection
tank. Apply downward pressure until
the casters snap into place. (Fig. 5)
6. Slide the rear wheels into the slots
making sure to match the wheel
number to the corresponding number
on the wheel slot and use screws to
secure them. Do not over tighten the
screw. (Fig. 6 & 7)
7. Your vacuum comes ready for dry
vacuum cleaning, if cartridge filter
is not installed refer to page 10 for
filter installation. (Fig. 8 & 9)
8. For wet vacuum cleaning, install the
supplied foam filter. (Fig. 10) See
page 11 for filter installation.
9. Place the power head back on the
collection tank, aligning the top
section with the latches, and lock
into place. (Fig. 11)
Loading ...
Loading ...
Loading ...