NTW4755EW0 User Manual

Loading ...

CYCLE STATUS LIGHTS INDICATOR

The Cycle Status Lights show the progress of a cycle.

At each stage of the process, you may notice sounds or

pauses that are different from traditional washers.

SENSING/FILL

When the START/Pause button is pressed, the washer

will ll to an initial water level and begin sensing to

determine the load size. If the lid is closed when

the washer is done sensing, the lid will lock and the

washer will continue lling to begin operation. The lid

will remain locked for the rest of the cycle unless the

cycle is Paused or Cancelled.

If the lid is open when the water stops entering the

washer, the cycle will not begin until the lid has been

closed and the START/Pause button is pressed. If the

cycle has not been started within 10 minutes of the

water lling the washer, the washer will pump out the

water.

NOTE: Avoid opening lid during sensing phase. The

sensing process will start over when the washer is

restarted. The Sensing/Fill light may also come on

during the Soak and Wash portions of the cycle. This

is normal. To restart the washer after the lid has been

opened press START.

WASH

You will hear the motor and agitator moving the load.

During the rst stage of the sensing/wash cycle,

water will partially ll the washer and then begin to

move the load. It is normal to have the sensing light

on during this stage. You will hear the agitator rotate,

followed by a several second pause. This process will

repeat for several minutes, allowing the entire load to

become saturated. The lower water level combined

with HE detergent at this stage allows for concentrated

cleaning. Concentrated cleaning delivers the detergent

directly to the soils. It is normal for the load to be

above the water line during this stage. At the beginning

of the second stage, the washer will add water to the

correct level based on the load size. You will hear the

agitator move quicker during this stage of the wash

cycle. The motor sounds may change at different

stages in the wash cycle.

RINSE

You will hear sounds similar to the wash cycle as the

washer rinses and moves the load. You may hear the

motor turning on briey (short hum) to move the basket

while lling.

FINAL SPIN

The washer spins the load at increasing speeds for

proper water removal, based on the selected cycle

and spin speed.

CYCLE COMPLETE

Once the cycle is complete, this light will come on.

Remove the load promptly for best results.

LID LOCKED

To allow for higher spin speeds, the

lid will lock and the Lid Locked light

will turn on. When this light is lit, the

lid is locked and cannot be opened.

When this light is blinking, the washer

is paused. When this light is off, the lid

can be opened.

After a cycle is started, water will

enter washer. Lid will be unlocked

during the Sensing/Fill process. If

you need to open the lid to add a

garment after this point, you must

press START/Pause and wait for the

lid to unlock. The lid will only unlock

after washer movement has stopped.

Depending on where in the cycle you try to pause, it

may take several seconds to several minutes for the

lid to unlock. Press START/Pause to resume the cycle.

Loading ...

User Manual - Page 5