CMEED400 Instruction Manual

Loading ...

This edger is intended for householduse.

use under wet conditions or in presence of

flammable liquids orgases.

let children come into contact with the tool.

Supervision is required when inexperienced operators use

thistool.

1. Remove knobs and curved head bolts from

handle tube mountingholes.

2. Remove tape which secures internal jacketed cable

totubes.

3. Slide middle tube

into upper tube and fasten

handle tubes together with the knob and curved head

bolt. Note that when you first insert the bolt it may

be necessary to wiggle it carefully to get it past the

jacketed cable inside the tube. There are two positions

available for adjustment to your preferred height

setting. See Figure G for upper handle orientation.

Ensure the cable moves smoothly into the handle tubes

whileassembling.

4. Push jacketed cable down into lower tube to remove

the slack. Slide the middle tube into the lower by

locating the groove and the bump. Fasten handle tubes

together with the remaining knob and curved head

bolt. Note that when you first insert the bolt it may

be necessary to wiggle it carefully to get it past the

jacketed wire inside thetube.

Be sure your power supply agrees with the nameplate

marking. Voltage decrease of more than 10% will cause loss

of power and overheating. These tools are factory tested; if

this tool does not operate, check power supply.

Fig.C

Fig.D

Loading ...

Instruction Manual - Page 6