Shark RV2502AE AI Ultra™ Self-Empty Robot Vacuum with XL HEPA Self-Empty Base

OWNER’S GUIDE - Page 19

For RV2502AE. Series: 2500
Also, The document are for others Shark models: AV2501AE, AV2511AE

PDF File Manual, 32 pages, Read Online | Download pdf file

RV2502AE photo
Loading ...
Loading ...
Loading ...
sharkclean.com/AIRobotSEsharkclean.com/AIRobotSE
MAINTENANCE
CLEANING AND REPLACING ROBOT'S FILTER
Remove and empty the dust bin. Clean any hair or
debris o the Anti-Tangle Comb on the back of
the dust bin.
Pull filter out of the dust bin by the tabs.
Lightly tap the filter to remove debris every time
you empty the dust bin.
Reinsert the filter into the dust bin, then slide the
dust bin back into the robot until it clicks into
place.
For optimal suction power, after each use, clean and reinsert the filter inside the robot's dust bin.
See sharkclean.com/AIRobotSE for replacement filters.
MAINTENANCE
CLEAN POST-MOTOR FILTER EVERY YEAR
Press the button at the top of the Filter Door, then
tilt the door and lift it o. Remove the Post-Motor
Filter from the base by pulling the tab down. Tap the
lters clean over the trash, then rinse them with cold
water ONLY, as soap may damage them. To reinstall
the post-motor filter, insert it into the base and
replace the filter door.
CLEAN PRE-MOTOR FILTERS ONCE A MONTH
To open the filter housing lid, hold the top left edge
of the base and pull up on the lid. With the lid open,
remove the foam filter by the top handle, then lift out
the felt filter underneath. Tap the filters clean over the
trash, Tap the filters clean over the trash, then rinse
them with cold water ONLY, as soap may damage
them. Allow filters to air-dry completely before
reinstalling them. The filters must be installed correctly
for the base to work properly. Reinsert the felt filter
rst, then the foam filter.
Regularly clean the the filters to keep your vacuum's suction power optimal.
To clean filters, rinse with cold water ONLY to prevent damage from cleaning chemicals. Allow all filters to
air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into electric parts.
CLEANING AND REPLACING THE BASE FILTERS
IMPORTANT: DO NOT use soap when cleaning the filters.
Filter
Door
NOTE: Make sure to insert the dust bin completely, until it clicks into place.
Loading ...
Loading ...
Loading ...