Loading ...
Loading ...
Loading ...
8
Installation Instructions
faucet base
1/4 turn to connect
faucet to base
screw
toggle bolt
rubber washer
hole in sink
or countertop
faucet
Step C - Install Faucet
1. Insert one end of the 3/8" blue tubing into the push-in fitting on the bottom of the faucet. Push tubing
t
hrough the collet and all the way into fitting. Full engagement is 3/4" length of tube into the fitting.
2
. Feed the 3/8" tubing that is attached to the faucet through the mounting hole. Slide the toggle bolts
through the mounting hole. Tighten the screws to secure the base flat on the mounting surface. Do not
overtighten.
3. Move the faucet down onto the base. Turn 1/4 clockwise to attach the faucet to the base.
4. Install battery in base. See “Battery Change” section for instructions.
FIG. 4
Step D - Make Tubing Connections
1. Allowing some slack, measure and cut a length of 3/8" tubing to connect between the supply fitting
and the filter system inlet (See Figure 2). Cut the ends of the tubing square.
2. Insert tubing all the way into the supply fitting and inlet fitting. Pull on the tubing to be sure that it's
held firmly in the fittings.
3. Repeat steps 1 and 2 to connect tubing from the faucet to the filter system outlet (See Figure 2).
Tubing Connection (all push-in fitting locations):
This system includes push-in fittings for quick tubing connections. If working with the fittings, do the fol-
lowing.
continued on the next page
blue tubing
Loading ...
Loading ...
Loading ...