Loading ...
Loading ...
Loading ...
EN
©2021 Hestan Commercial Corporation
11
INSTALLATION OF ANTI-TIP DEVICE
(CONTINUED)
ANTI-TIP BOLT ADJUSTMENTANTI-TIP BOLT ADJUSTMENT
After leveling the range, and after the bracket has been attached, adjust the anti-tip bolt and large
washer under the range so the top of the washer is 1-1/4” [3.2 cm] maximum from the floor. Slide
the range into the opening of the bracket and verify the bolt is engaged in the bracket as seen
below. Carefully tip the range forward to check. The range should not move more than 1” [2.5 cm].
ELECTRICAL CONNECTIONS
ELECTRICAL SHOCK HAZARDELECTRICAL SHOCK HAZARD
Disconnect power before installing or servicing appliance. Before turning
power ON, be sure all controls are in the OFF position. Failure to do so can
result in electrical shock or death.
ELECTRICAL GROUNDINGELECTRICAL GROUNDING
This appliance must be grounded. Grounding reduces the risk of electric
shock in the event of a short circuit. Grounding through the neutral conductor is prohibited for
new branch circuit installations (1996 NEC), mobile homes, and recreational vehicles, or in an area
where local codes prohibit it. This range has been setup at the factory for a 4-wire connection.
CAUTION
Improper grounding will cause malfunctions in the unit. This can
damage the appliance and create a shock hazard condition.
ELECTRICAL CONNECTIONELECTRICAL CONNECTION
The appliance must be connected using the cordset provided. The appliance must be on its own
dedicated circuit - 240 VAC, Single Phase, 60 Hz, with a current rating as shown in the model
number listing on page 2. The installation must be done in accordance with local codes, or in the
absence of local codes, it must be installed in accordance with the National Electrical Code, ANSI/
NFPA 70.
For both US and CANADA installations: This appliance is equipped
with copper lead wires and must be connected to copper wires only.
Improper connection of aluminum house wiring can result in a fire or
shock hazard. Use only connectors designed and certified for
connecting to aluminum wire, and installed by a qualified electrician.
Loading ...
Loading ...
Loading ...