Loading ...
Loading ...
Loading ...
LED WORKL1GHT (Fig. 12)
The LED worklight located on the base of the
drill will come on when the trigger switch is
depressed, The LED worklight will turn off when
the trigger switch is released° This provides
additional lighting on the surface of the
workpiece for operation in lower-light areas.
BIT STORAGE (Fig. 13)
When not is use, the bit provided with the
drill can be stored on the base of the drill by
snapping it into place in the bit clip.
Fig. 13 Bit clip
Fig. 12
LED
worklight
INSTALLING BITS (Fig. 14)
[] Lock the trigger switch by placing the
direction of rotation selector in the OFF
(center) position,
[] Open or close the chuck jaws to a point
where the opening is slightly larger than the
bit size you intend to use., Also, raise the front
of the drill slightly to keep the bit from falling
out of the chuck jaws.
I_ Insert a drill bit.
NOTE: Rotate the chuck body in the
direction of the arrow marked GRIP to
close the chuck jaws° Do not use a wrench
to tighten or loosen the chuck jaws,
[] Tighten the chuck jaws securely on the bit,,
REMOVING BITS (Fig,, 14)
[] Lock the trigger switch by placing the
direction of rotation selector in the OFF
(center) position.
[] Open the chuck jaws,,
NOTE: Rotate the chuck body in the
direction of the arrow marked OPEN to
open the chuck jaws. Do not use a wrench
to tighten or loosen the chuck jaws.
[] Remove the drill bit°
Drill bit
Ratcheting
keyless
chuck
OPEN
(release)
Chuck
jaws
Chuck
body
F_g. 15
WRONG!
WRONG!
_kWARN_HG: Make sure to insert the drill bit straight into the chuck jaws. Do not
insert the drill bit into the chuck jaws at an angle then tighten, as shown in figure 15,
This could cause the drill bit to be thrown from the drill, resulting in possible serious
personal injury or damage to the chuck,
18
Loading ...
Loading ...
Loading ...