Loading ...
Loading ...
Loading ...
Installation Instructions
INSTALLING THE ANTI-TIP FLOOR BRACKET Ion21ft. models}
-ZIWARNING
Under certain circumstances, this refrigerator
can tip forward.
Injury to persons can result.
Install Anti-Tip Bracket packed with this
refrigerator.
[] MEASURE CABINET OPENING
AVAILABLE VS. REFRIGERATOR WIDTH
Measure width of cabinet opening where
refrigerator will be placed, W.
Be sure to account for anLI countertop
overhang, baseboard thickness and anLI
clearance desired. Width, W, should not be less
than 36 inches. The refrigerator will be placed
approximatelLI in the middle of this opening.
Baseboard
RearWall Thickness
or Countertop
_i i_ Overhang
, (Whichever
W _"' Is Greater)Plus
Any Desired
Clearance
REFRIGERATOR
RHSide
Front
[]
%
LOCATING THE ANTI-TIP
FLOOR BRACKET
Place the anti-tip floor bracket Iocator template
(included inside the anti-tip kit) onto the floor
up against the rear wall, within W, and in line
with the desired location of the RH side of the
refrigerator (see Figure 1).
Figure1 - Installation Overview
2 Wall Holes
Refrigerator Sheet
rB] Place the anti-tip floor bracket onto the Iocator
template with its RH floor holes lined up with
the floor holes indicated on the template sheet,
approximatelg 7Ya" from the edge of the sheet
or the RH side of the refrigerator.
E] Hold down in position and use the anti-tip floor
bracket as a template for marking the holes
based upon Llour configuration and tLIpe of
construction as shown in Step 3. Mark the hole
locations with a pencil, nail or awl.
NOTE:
• It is REQUIRED to use at least 2 screws to
mount the floor bracket (one on each side of
the anti-tip floor bracket). Both must be into
either the wall or the floor. Figure 2 indicates
all the acceptable mounting configurations
for screws. Identifg the screw holes on the
anti-tip floor bracket for gour configuration.
16
Loading ...
Loading ...
Loading ...