Liebherr 1051869 2 Piece Kitchen Appliances Package with HC1030 24 Inch Bottom Freezer Refrigerator and UB501 20 Inch Compact Refrigerator in Panel Ready

User Manual - Page 11

For 1051869.

PDF File Manual, 14 pages, Read Online | Download pdf file

1051869 photo
Loading ...
Loading ...
Loading ...
Problem Possible Cause Correction
A gurgling
sound
This sound comes from the refrig-
erant flowing in the refrigeration
circuit.
u
The sound is normal.
A faint clicking
sound
The sound always occurs when the
refrigeration unit (the motor) automat-
ically switches on or off.
u
The sound is normal.
A hum. It is
briefly a little
louder when the
refrigeration unit
(the motor)
switches on.
The refrigeration increases automati-
cally when fresh food has just been
placed in the appliance or the door
has been left open for a while.
u
The sound is normal.
The ambient temperature is too high.
u
Solution: (see 1.3)
The fan
continues to run.
With the “hydro” setting the fan must
run for longer for operational
reasons.
u
This is normal.
Vibration noise
The appliance is not standing firmly
on the floor. As a result, objects and
adjoining units are set into vibration
by the running refrigeration unit.
u
Check the installation and realign the appliance if
necessary.
u
Move bottles and containers apart.
Flow noise on
the soft stop
mechanism.
The sound is caused by the soft stop
mechanism.
u
The sound is normal.
The temperature
display indi-
cates: F0 to F9.
There is a fault.
u
Contact the customer service department (see Main-
tenance).
DEMO lights up
in the tempera-
ture display.
The demo mode is activated.
u
Contact the customer service department (see Main-
tenance).
The outside
surfaces of the
appliance are
hot*.
The heat of the refrigerant circuit is
used to prevent condensate from
forming.
u
This is normal.
The temperature
is not cold
enough.
The door of the appliance is not
closed properly.
u
Close the appliance door.
Insufficient ventilation.
u
Clear and clean the ventilation grille.
The ambient temperature is too high.
u
Solution: (see 1.3)
The appliance was opened too
frequently or for too long.
u
Wait to see whether the required temperature resets
itself by itself. If not, contact the customer service
department (see Maintenance).
The temperature is incorrectly set.
u
Set to a colder temperature and check after 24 hours
The appliance is too near to a heat
source (stove, heater etc).
u
Change location of appliance or the heat source.
The appliance was not properly
installed in the recess.
u
Make sure the appliance was installed correctly and
the door closes properly.
The appliance is not switched on.
u
Switch on the appliance.
Troubleshooting.
* Depending on model and options 11
Loading ...
Loading ...
Loading ...