Loading ...
Loading ...
Loading ...
refrigeratorsection.Twistcartridgeleft¼turnand
pulldowntoremove.Savebypassforuseatalater
date.
2. SeeWater Filtration System Installation and
Operation Instructions provided with water filter
cartridge for filter installation and operation.
Install Air Filtration Cartridge
Cartridge should be replaced every three months. Strong
food odors(ke, unwrapped onions, gartic, etc.) will shorten
life of cartridge.
1. Locate air filtration asembly at air return of
refrigeration cabinet. Fitterholder(A)isattachedto
cabinet by velcro. Pull holder off cabinet watt.
2. Locate odor fitter inside hotder. Filter stides out.
3. Insert replacement cartridge by stiding into
grooves(B).
if repair is attempted. The correct type of shut-off valve
requires a V4"hole to be drilled in the water supply pipe
before valve attachment. Sears is not responsible for
property damage caused by improper water
connection.
Materials Required
1/4"O.D.(6 mm) flexible copper tubing is required. Length
of copper tubing must reach from water supply
connection to water valve inlet port on back of
refrigerator, plus additional 8' (2 m) of tubing for a service
loop. A service loop wilt allow refrigerator to be pulled
away from the wall without disconnecting tubing.
Procedure
1. Remove plastic cap(A) from water valve inIet port(B).
B
II'1
¢3
I'"
m
Connect ice maker water supply line
WARNING I
To avoid electrical shock which can cause severe
personal injury or death, disconnect power to
refrigerator before connecting water supply. After
connecting water supply, connect power.
CAUTION
Observe the following to avoid property damage:
• Verify that bypass cartridge has been removed and
replaced with water filter in water filter assembly.
• Make sure water pressure to water valve is
between 20 and 100 pounds per square inch.
• Tighten adapter fitting and nuts with pliers and
wrenches. Do not overtighten.
• Checkforwaterleaksand correct if necessary
before returning refrigerator to normal location. After
24 hours check again for leaks.
Important
• Before connecting water supply, contact a plumber to
connect copper tubing to household plumbing in
compliance with local codes and ordinances.
• Sears does not recommend using a self-piercing, or
3h6"saddle valves! Both reduce water flow, become
plugged with sediment over time and may cause leaks
5
2. Place brass nut(O) and brass sleeve(C) on copper
tubing(B). (Brass nutand sleeve are found in your
literature packet.) Insert copper tubing into water
valve inlet port(E). Connect brass nut on copper
tubing to water valve inlet port. Make sure copper
tubing is secure by pulling on copper tubing.
3. Turn on water supply to refrigerator and check for
leaks. Correct any leaks at connection. Be careful not
to overtighten connection.
4. Create a service loop using extreme care to avoid
kinks. Secure copper tubing to refrigerator cabinet
with a "P" clamp(A).
i
<
Loading ...
Loading ...
Loading ...