Loading ...
Loading ...
Loading ...
BEFORE CALLING FOR SERVICE
Staining
Washer will not
turn ON
Door wlll not un-
lock
when cycle is
stopped or
paused
Wash cycle time is
longer than usual
Musty or mildewy
odor in washer
Wrinkling
Bleach or softener dispensed
too soon.
Bleach or softener was added directly to the
wash load in the drum.
Washer was not unloaded promptly.
Clothes were not properly sorted
Power cord is not properly plugged in.
House fuse is blown, circuit breaker has
tripped, or power outage has occurred.
House fuse is blown, circuit breaker has
tripped, due to multiple appliances on
one outlet.
Interior temperature of washer is too high.
Water level in washer is too high.
The washer automatically adjusts the
wash time for the amount of laundry,
water pressure, water heating time and
other operating conditions.
Incorrect or too much detergent has
been used.
Inside of drum was not cleaned properly.
Washer not unloaded promptly.
Washer overloaded.
Hot and cold water inlet hoses are
reversed.
Dispenser compartment is overfilled causing bleach or
softener to dispense immediately.
Dispenser drawer closed too quickly causing bleach or
softener to dispense immediately.
Laundry chemicals must be loaded into the dispenser.
Always remove items from the washer as soon as pos-
sible after the cycle iscomplete.
Always wash dark colors separately from light colors
and whites to prevent discoloration.
Never wash heavily soiled items with lightly soiled
items.
Make sure that the plug is plugged securely into a
grounded, 3-prong, 120-VAC, 60-Hz outlet.
Reset circuit breaker or replace fuse. Do not
increase fuse capacity. If the problem is a circuit
overload, have it corrected by a qualifled electri-
cian.
Reset circuit breaker or replace fuse. If more than
one appliance is connected to the outlet, call an
electrician to have an additional circuit installed.
The washer door has a safety feature to prevent
personal injury. For example, if the washer is
paused during the hot wash stage of a cycle, the
interior temperature of the drum will be very hot,
so the door will not unlock. This is normal.
Allow the washer to cool until the DOOR LOCI(
indicator turns OFF on the display.
To drain the water, press POWER, then press the
SPIN SPEED button without selecting a cycle.
This is normal. The washer adjusts cycle time
automatically to provide optimal results for the
selected cycle. The time remaining shown in the
display is only an estimate. Actual time may vary.
Use only High-Efficiency (HE) detergent in accordance
with the manufacturer's instructions.
Run the CLEAN WASHER cycle O regularly. Be sure to
wipe around and under the door seal frequently. See
Care and Cleaning of the Interior.
Clean around door seal/glass to prevent odor.
Always remove items from the washer as soon as the
cycle is complete.
When washing large loads, do not overstuff: the drum.
The washer can be fully loaded, but the drum should
not be tightly packed and the door should close easily.
Hot water rinse can set wrinkles in garments.
Check the inlet hose connections.
3O
Loading ...
Loading ...
Loading ...