Loading ...
Loading ...
Loading ...
www.newair.com 9
ASSEMBLY & INSTALLATION
BEFORE USING YOUR APPLIANCE
Remove the exterior and interior packing.
Before plugging in the fridge, let it stand upright for approximately
24 hours.
Doing this will reduce the possibility of a malfunction in the cooling system
from handling during transportation.
Clean the interior surface with lukewarm water using a soft cloth.
Install the handle on the door, if it is not already attached (See detailed
instructions below)
INSTALLING THE FRIDGE
This fridge is designed to be either built-in or freestanding.
Place your fridge on a floor that is strong enough to support it when it is fully
loaded. To level the unit, adjust the front leveling legs, or the screws on the
wheels.
Make sure that the air vent at the front of the appliance is never covered or
blocked in any way.
Note: It is recommended that you do not install the appliance near an oven,
radiator or other heating source. Any nearby heat sources may increase
electrical consumption. Do not install in a location where the temperature will
fall below 50°F (~10°C) or above 110°F (~43°C). For best performance, do not
install the fridge behind a cabinet door or block the vent in the front.
Avoid installing the fridge anywhere with excessive moisture.
Plug the fridge into a properly grounded wall outlet. Do not plug the fridge into
a power strip or extension cord.
Loading ...
Loading ...
Loading ...