Loading ...
Loading ...
Loading ...
STEP 10: (SEE FIGURE 10)
* Fasten the end plates to the corners of the tray using
eight 5/16" x 3/4" hex bolts and 5/16" nylock nuts. Do
not tighten till step 12.
5116" x 314"
HEX BOLT
/
5/16" NYLOCK NUT
FIGURE 10
STEP 11: (SEE FIGURE 11)
* Place the lift handle through the slot in the tray.
Fasten the lift handle to the smaller, inner hole in the
middle wheel bracket using the bolt and nut which
you pre-assembled earlier (figure 2). Fasten the lift
handle to the larger, outer hole in the wheel bracket
using a 3/8" x 1-1/4" hex bolt, the shoulder spacer,
and a 3/8" nylock nut. Tighten both nylock nuts.
* Push the grip onto the lift handle.
318" x 1-114"
HEX BOLT
/
GRIP
3_"NYLOCK NUT
PRE-ASSEMBLED
NUT AND HEX BOLT
FIGURE 11
8
STEP 12: (SEE FIGURE 12)
* Perform the following steps in sequence to assure
secure locking of the lift handle.
a. Turn the aerator upright, then place the lift handle
into the transport locking notch at the front end of
the slot in the tray.
b. Stand on the right side of the aerator and push
against the tray, which will force the lift handle over
to the right side of the notch.
c. Keep the tray and lift handle in this alignment and
tighten the eight bolts at the corners of the tray.
d. Tighten the two bolts which fasten the middle
brace to the tray.
e. After performing these steps, some effort should
be required to shift the lift handle from the trans-
port locking notch over into the slot to lower the
aerator. When the aerator is raised, the lift handle
should spring back over into the transport locking
notch.
PUSH AGAINST
THIS SIDE
FIGURE 12
Call 1-866-576-8388 for missing parts or assembly help
DO NOT RETURN TO STORE
Loading ...
Loading ...
Loading ...