Loading ...
Loading ...
Loading ...
TOOLS REQUIRED FOR ASSEMBLY
(2)
(2)
(2)
(2)
7/16" wrenches
1/2" wrenches
9/16" wrenches
3/4" wrenches or adjustable wrenches
CAUTION: POINTS OF AERATOR
KNIVES ARE SHARP! EXERCISE
CAUTION AT ALL TIMES WHILE
ASSEMBLING AND USING THE
AERATOR.
STEP 1: (SEE FIGURE 1)
* Assemble eight aerator knives on the outside of each
double spool assembly. Rotate each knife to insert
the locking tab into the spool plate, then align the
square holes and secure with a 5/16" × 3/4" carriage
bolt, a 5/16" Iockwasher, and a 5/16" nylock nut.
* Push split plastic bearings into both ends of each
double spool tube.
5116" x 314"
CARRIAGE BOLT
SPLIT \
BEARING
5116" LOCK
WASHER
5116"
NYLOCK NUT
/
FIGURE 1
SPLIT
BEARING
STEP 2: (SEE FIGURE 2)
* Assemble a wheel bracket to the middle hole in the
shaft so that the hub of the bracket faces the short
end of the shaft. Fasten the bracket to the shaft
using a 1/4" x 1-3/4" hex bolt and a 1/4" nylock nut.
Tighten.
* Pre-assemble a 3/8" x 1-1/4" he× bolt and a 3/8"
nylock nut to the smaller hole in the wheel bracket.
insert the bolt from the hub side of the bracket. Do
not tighten till step 12.
SHORT END
OF SHAFT
318" x 1-114"
HEX BOLT
1/4"
NYLOCK NUT
!
114"x 1-314"
HEX BOLT
NYLOCK NUT
FIGURE 2
STEP 3: (SEE FIGURE 3)
* Assemble a double spool assembly, a 5.29" long
spacer, another double spool assembly, a 1.00" long
spacer and a 3/4" fiat washer onto the short end of
the shaft.
3/4" FLAT
WASHER
1.OO"LONG
SPACER
5.29" LONG
SPACER
SHORT END
FIGURE 3
Call 1-866-576-8388 for missing parts or assembly help 5
DO NOT RETURN TO STORE
Loading ...
Loading ...
Loading ...