Loading ...
Loading ...
Loading ...
REMOVABLE OVEN DOOR
To remove:
1. Open the door to the stop position (see Illustration).
2. Grasp the door at each side and lift up and off the
hinges. DO NOT lift door by the handle; door glass
breakage or damage to the door could result.
NOTE: When the door Is removed and hinge arms are at
stop position, do not bump or try to move the hinge
arms. The hinges could snap back causing an Injury to
the hands or damage to the porcelain on the front of the
range. Cover the hinges with toweling or empty towel
rolls while working in the oven area.
To replace:
1. Hold the door over the hinges with the slots at the
bottom edge of the door lined up with the hinges.
The hinge arms must still he In the stop position.
2. Slide the door down onto the hinges as far as It will
go and close the door.
E.
NOTE: Do not allow water to mn down inside the door.
Opendoor completelywhen cleaningthetop edge.
REMOVABLE OVEN RACKS
Be careful not to scratch the oven finish when Installing
or removing oven racks.
To install:
1. Set the raised back edge of the rack on a pair of rack
guides.
2. Push the rack In until you reach the bump In the rack
guide, then lift the front of the rack a bit and push the
rack all the way In.
To remove:
1. Pull the oven rack out, then up, In one motion. See
the cleaning chart.
BUMP
IN RACK
GUIDE
NOTE: (A) The racks are deslgned wlth stop locks. When placed correcUy on the rack support and extended from
the oven, the stop lock prevents the racks from tilting when you are removing food from the racks or placing
food on them.
(B) For best performance, remove oven racks during self-clean cycle. If oven racks are left in the range
during a clean cycle, they will darken, lose their luster and become hard to slide. Ifyou choose to leave the
racks In theoven, you can pellsh the edges ofthe racks withsteel wool and apply a small amount ofvegetable
oll to the rack edges after the self-clean cycle. This will make the racks easier to slide.
REPLACING OVEN LIGHT
;I
Do not touch hot oven bulb. Do not
touch bulb with wet hands. Never
wipe oven light area with wet cloth.
Never touch the electrically live metal
collar on-the bulb when replacing.
To remove:
1. Disconnect electric power to the oven at the main
fuse or circuit breaker.
2. Hold your hand under cover and firmlypush backthe
bail wire until it clears the cover. The cover will fall
into your hand. DO NOT REMOVE ANY SCREWS
TO REMOVE THE COVER.
3. Replace bulb with 40-watt home appliance bulb.
To replace cover.
1. Place cover Into groove of lamp receptacle. Pullwire
bail forward until it snaps into place. Be certain wire
bail is in center of cover. Wire will held cover firmly
when in correct position.
2. Connect power to oven.
BULB SOCKET
13
BULB COVER BAIL WIRE
NEMNT09-3
Loading ...
Loading ...
Loading ...