Loading ...
Loading ...
Loading ...
• 5 •
IMPORTANT: If you are using the power converter to operate a battery
charger, monitor the temperature of the battery charger for about 10
minutes. If the battery charger becomes abnormally warm, disconnect it
from the converter immediately.
NOTE: You may hear a “buzzing” sound being emitted from inexpensive sound
systems when operated with the converter. This is due to ineffective lters in the
sound system’s power supply. Unfortunately, this problem can only be resolved by
purchasing a sound system with a higher quality power supply or higher quality lter.
4. OPERATING INSTRUCTIONS
CONNECTING THE CONVERTER
IMPORTANT: Make sure you connect your converter to a 12V power supply only.
1. Remove the cigarette lighter from its outlet.
2. Push the 12 volt power plug rmly into the outlet.
ATTENTION: Failure to make the correct connections will result in blown fuses and
permanent damage to the converter.
3. The LED indicator light should glow GREEN, verifying the converter is
receiving power.
NOTE: You may hear a “buzzing” sound being emitted from the cooling fan.
4. Make sure the device to be operated is turned OFF.
5. Plug the device into the converter’s AC outlet or USB port.
6. Turn the device on.
7. To disconnect, reverse the above procedure.
NOTE: If more than one device is to be powered, start one device at a time to avoid a
power surge and overloading the converter. The surge load of each device should not
exceed the converter’s Continuous Operation wattage rate.
5. POWER SOURCE
Your average automobile or marine battery at full charge will provide an ample
power supply to the converter for approximately 3 hours when the engine is off.
The actual length of time the converter will function depends on the age and
condition of the battery and the power demand being placed by the device being
operated with the converter.
If you decide to use the converter while the engine is off, we recommend you turn
OFF the device plugged into the converter and disconnect the converter’s plug
from the 12 volt accessory outlet before starting the engine. To maintain battery
power, start the engine every 2 to 3 hours and let it run for approximately 10
minutes to recharge the battery.
Loading ...
Loading ...
Loading ...