Loading ...
Loading ...
Loading ...
40 / EN
Washer-Dryer / User Manual
There is detergent left on the laundry.
• Machine might have been overloaded. >>>
Do not overload
the machine.
• Wrong programme and temperature might have been selected.
>>>
Select the right programme and temperature for the
laundry to be washed.
• Wrong detergent might have been used. >>>
Select a proper
detergent for the laundry to be washed.
Too much foam forms in the machine. (**)
• Improper detergents for the washing machine might have been
used. >>>
Use detergents suitable for washing machine.
• Excessive amount of detergent might have been used. >>>
Use only sufficient amount of detergent.
• Detergent might have been stored under inappropriate
conditions. >>>
Keep the detergent in a closed and dry area.
Do not store it in excessively hot places.
• Meshed laundry such as tulles might foam too much due to
their texture. >>>
Use less detergent for these types of fabrics.
• Detergent might have been put in the wrong compartment.
>>> Put the detergent in the correct compartment.
• Softener is taken early. >>> There might be a problem with the
valves or the detergent drawer. Call the Authorised Service Agent.
Foam is overflowing from the detergent drawer.
• Excessive amount of detergent might have been used.
>>>>
Mix 1 tablespoonful softener and ½ l water and pour
into the main wash compartment of the detergent drawer.
• Put detergent into the machine suitable for the programmes
and maximum loads indicated in the “Programme and
consumption table”. If you use additional chemicals (stain
removers, bleaches and etc), reduce the amount of detergent.
Laundry remains wet at the end of the programme. (*)
• Excessive foam might have formed due to use of too much
detergent, and the automatic foam absorption system might have
been activated. >>> Use the recommended amount of detergent.
(*) Machine does not switch to spinning step
when the laundry is not evenly distributed in the
drum to prevent any damage to the machine
and to its surrounding environment. Readjust
the laundry and perform spinning again.
(**) The drum might not have been cleaned
regularly.
>>>
Clean the drum regularly. See 6.2
A
CAUTION!
• If you cannot eliminate the problem
although you follow the instructions in
this section, consult your dealer or the
Authorised Service Agent. Never try to
repair a nonfunctional product yourself.
Drying lasts too long.
• Excessive laundry loaded. >>>
Do not load the machine
in excess.
• Laundry is not spun enough.>>> Spin at a higher spin
speed in washing step in the Dryer-Washing Machine.
• Tap is turned off. >>> Turn on the taps.
Laundry is still damp after drying.
• An appropriate programme according to laundry
type might is not selected.>>>
Check care labels on
clothes and select an appropriate programme or use timed
programmes in addition.
• Excessive laundry loaded. >>> Do not load the machine
in excess.
• Laundry is not spun enough.>>> Spin at a higher spin
speed in washing step in the Dryer-Washing Machine.
Machine does not start or programme cannot be started.
• Power cable is not connected. >>> Make sure the power
cable is connected.
• Programme is not set or Start / Pause / Cancel button
is not pressed. >>>
Make sure the programme is set and
it is not in Stand-by mode.
• Child lock enabled. >>> Disable Child lock.
Loading door cannot be opened.
• Your machine’s door is not opened for safety
reasons.>>>
If door locked indicator is still active on display
after drying, machine keeps the loading door locked until it
cools for your safety.
• The loading door will not open if there is no power.
>>>
To open the loading door, open the pump filter cap and
pull down the emergency handle positioned at the rear side of
the said cap. See “Loading door lock”
A
WARNING!
• Check the HomeWhiz section for the
relevant troubleshooting information.