Loading ...
Loading ...
Loading ...
ReversibIe Door
nstructions (continued)
Freezer Door
Lo_l: _a_dt_ Ove_
Do_elalt _guZlon
_ Frame
_tie "'_- _* "' - Magnetit
w_
7, (When needed, please refer to your literature
pack). Reverse handles while doors are off Remove the
two screws attaching the handle to the bottom of the
freezer door Swing bottom of handle away from the
door and slide handle straight up and off of dovetail
button Remove screw and dovetail button and install
on other side using the same holes asthe nameplate To
move nameplate to other side, remove the nameplate
from its frame, turn frame upside down and install in
old handle holes Insert nameplate into frame Reverse
instructions for reattachJng handle Start with handle
offset away from the door Place top of handle over
dovetail button, swing handle into an upright position
and push upward, locking it into place Secure bottom
of handle with screws
Hinge,Pin ;
i
Washer / _
s / . ."
ยข-_ b 1' "'--
Bolls LowerHinge
Or
Washer
Lower Hinge
Bolts
9r Using a putty knife, remove black plastic
plug (in some models) from front of base,
and reinstall in opposite set of lower hinge
holes Assemble lower hinge to cabinet
Install hinge pin in opposite hinge hole from
which it was removed Install the washer
(some models) on the lower hinge pin and
insert hinge bolts, but do not tighten
Hinges will have to remain loose against
cabinel to align door
I 8. (When needed, please refer
!to your literature pack)To
remove handle: Remove the
two screws attaching the handle
to the top of the refrigerator door
Swing the top of handle away_
from the door an slide handle
down and off of dovetail button
Remove screw and dovetail button
and instait on other side. moving
hole plugs from corresponding
holes to the opposite side Reverse
instructions for reattaching
handle Start with the handle
offset away from the door Piece
bottom of handle over dovetail
'button, swing handle into an
upright position and push
downward, locking it into place
Secure top of ha ndle with screws
_,{mt_ Trim Removal (Full-Length Trim
models only):
In some models, the refrigerator door has a full tenothtri__ m piece which
continues from the bottom of the handle to the bottom of the door The
top of the trim fits into the base of the handle An adhesive "trim lock" is
positioned about half-way down The bottom of the trim is held in place by
either an adhesive trim lock, or a trim lock"with two pronc?s inserted into a
hole on the face of the door Remove the trim by gently pulling the trim lock
areas out and away from the door When the trim is free from the door,
gentJy pul} the trim down and away from the base of the handle
To Reattach Trim: Slide both trim locks out of trim Insert the new adhesive
trim locks contained in your literature pack NOTE; Trim lock must be
removed and installed by sliding OVER _he two donut shaped areas Install
trim to handle bysliding under base of handle Carefully align trim and press
down at trim lock locations Replace hole plug on opposite side Use
rubbing alcohol [o remove any adtqeswe residue from old trim tock
tocation(s)
10. Turn center hinge upside down and
secure to cabinet asshown, using the screws
which are in the new hotes Instaft
refrigerator door on lower hinge pin Align
door with edge of cabinet Hold the door on
front of cabinet
Loading ...
Loading ...
Loading ...