Loading ...
Loading ...
Loading ...
FigureI showsthesnowthrowerintheshippingposition.
Figure2 showsthesnowthrowercompletely assembled.
Reference to the right and left hand side of the sndw
thrower isfrom the operator'spositionat the handle.
TO REMOVE SNOW THROWER
FROM CARTON (See Fig 1)
• Removetop pallet and discard.
• Cut allfour comers ofthe cartonfrom topto bottom
and laythe panelsfiat.
• Cut the cable ties attached tothe auger.
• Cutanddiscardtheplastictiesthatsecurethecrank
assemblyand place the assemblyaside.
• Removethepackingmaterialfromthe controlpanel.
• Cut and discard the packing securing the clutch
cablesto the lowerhandle.
With two 9t16 inch wrenches, loosen (do not
remove) both bolts securingthe upper and lower
handles. Swingthe upperhandle intotheoperating
position.
NOTE: ifthecables havebecome disconnectedfromthe
clutchlevers,reinstallthe cables as shown in Figure3.
• Tightenbothboltssecurely.
Rollthe snowthroweroffthe skid by pullingonthe
handle.
NOTE: This snowthrowerisequipped with a trackdrive
and canbe hardto pushwhen the engine is notrunning.
Itiseasierto pullthe snowthrower backwardifitmustbe
moved withoutthe engine running.
The drive system may be tightwhen you firstuse your
snowthrower. Itloosensup as you use it.
HOW TO SET UP YOUR SNOW
THROWER
• Forpacking,the heightadjustskidswere mounted
with the bottom lip tumed inward. Remove skid
mounting nuts (Fig. 2) and remount withthe lip
outward.
To adjusttheskidheightfordifferent conditions,see
To AdjustSkidsHeights paragraph on page 18.
CAUTION: IF YOU ARE REMOVING
A SNOW FROM ANY ROCKY OR UNEVEN
SURFACES, RAISE THE FRONT OF THE
SNOW THROWER BY MOVING THE
SKIDS DOWN. THIS WILL HELP TO PREVENT
ROCKS AND OTHER DEBRIS FROM BEING
PICKED UP AND THROWN BY THE AUGER.
LOWER HANDLE
CRANK
CLUTCH
CABLE
FIG. 1
UPPER
HANDLE
. ASSEMBLY
FIG. 2
im i
DRIVE
LEVER
FIG. 3
7
Loading ...
Loading ...
Loading ...