Loading ...
Loading ...
Loading ...
30
Using the Touch Controls
• The controls respond to touch, so you don’t
need to apply any pressure. Use the ball of
your finger, not its tip.
• You will hear a beep each time a touch is
registered.
• Make sure the controls are always clean, dry, and that there is no object
(e.g. a utensil or a cloth) covering them. Even a thin film of water may
make the controls difficult to operate.
For Touch/Slider Control Models
To Start Cooking
After the cooktop is connected to a power source, the cooktop will beep once,
all the indicator lights will illuminate for one second, then go out. To then start
cooking, follow these steps:
1. Press and hold the ON/OFF control button for about 3 seconds till
you hear a “beep” to turn the cooktop on. Now the cooktop enters
Standby mode. All of the heat setting indicators and the timer setting
indicator shows “-”.
2. Place a suitable pan on the cooking zone you wish to use. Make sure the
bottom of the pan and the surface of the cooking zone are clean and dry.
3. Set heating level of cooking zone:
a. Before adjusting the heating level, touch the heating zone selection
control button to select and activate the cooking zone you wish to use.
b. The heat setting indicator of the selected zone will flash when it is
active.
c. Adjust its heat level by touching the or button to decrease or
increase the heat, respectively. The heat level will cycle from 0 to 9.
d. If you have a slider control model, use the slider control in
increase/decrease as shown below:
Loading ...
Loading ...
Loading ...